Alera Lighting QST Parabolic Louver User Manual
Quest parabolic louver tid
© 2010 Alera Lighting, a division of Hubbell Lighting, Inc. Because of continuing product improvement programs, Alera Lighting reserves the right to change specifications
without notice. 701 Millennium Blvd. Greenville, SC 29607 / Tel 864.678.1000 / Tech Support 864.678.1580 / Website www.aleralighting.com
Page 1/2 Rev. 07/23/10
CuRveS / Quest Parabolic louver
Quest Parabolic louver tiD
technical installation Data
Step 1
Each louver has two aligners at one end. If this is a 4' or smaller single
unit or the last louver in the row, remove the aligners. If not, be sure
to point the end of louver with aligners toward the middle of row.
installation Data
Step 2
Slip outer edge of louver on outside lip of fixture housing.
Step 3
Insert end of tether into hole in socket pan.