Mmr, mmra plaster – Alera Lighting MMR, MMRA Plaster User Manual
Page 2
© 2009 Alera Lighting, a division of Hubbell Lighting, Inc. Because of continuing product improvement programs, Alera Lighting reserves the right to change specifications
without notice. 701 Millennium Blvd. Greenville, SC 29607 / Tel 864.678.1000 / Tech Support 864.678.1580 / Website www.aleralighting.com
Page 2/2 Rev. 08/26/09
ReCeSSed / MMR, MMRA P TID
MMR, MMRA PlAsteR
Technical Installation Data
instAllAtion instRuctions
Cut opening to prescribed dimensions.
1.
Add structure around perimeter of opening, as necessary, for supporting wing hangers.
2.
Remove shielding from fixture and set aside.
3.
Insert Phillips head screwdriver through hole in housing engaging wing hanger screwhead. Turn screwdriver clockwise to orient wing
4.
hanger parallel with fixture body. (Repeat 4 times)
Remove supply wire access plate from top of fixture housing.
5.
Attach access plate to supply flex.
6.
Raise fixture to ceiling. Make electrical connections to fixture and reattach access plate.
7.
Pass fixture thru opening until fixture housing trim is flush with ceiling.
8.
Insert Phillips head screwdriver through hole in housing engaging wing hanger screwhead. Turn screwdriver counter clockwise to open
9.
wing hanger assembly so it is resting on structure around perimeter of opening. (Repeat 4 times and screw each assembly until tight)
Mud/plaster up to aperture of fixture.
10.
Install lamps in fixture.
11.
Install shielding.
12.
Closed
Open
Channel
Wing Hanger
Assembly