Alpha Technologies SPI - Manual

Power
®
Alpha Technologies reserves the right to make changes to the products and information contained in this document without notice.
Copyright © 2008 Alpha Technologies. All Rights Reserved. Alpha
® is a registered trademark of Alpha Technologies. member of The Alpha Group™ is a trademark of Alpha Technologies.
745-997-C0-001, Rev. A (06/2008) To report errors in this document, send email to [email protected]
For more information visit www.alpha.com
United States Bellingham, Washington Tel: 360 647 2360 Fax: 360 671 4936
Canada Burnaby, British Columbia Tel: 604 430 1476 Fax: 604 430 8908
member of The Group TM
SPI Installation Instructions
1. 2. 3.
Tools Required:
• Channel lock pliers
• 1" torque wrench set
to 130 in/lbs
Assembly Time:
Approx. 10 minutes
Locate opening for SPI
installation. A knockout is
reserved for installation of a
secondary SPI (if required). Hold the SPI in place using
channel lock pliers while
tightening nut. Torque to
130 in/lbs. Connect SPI to power supply.
For wiring instructions, refer
to the XM Series 2 Technical
Manual, which can be
downloaded at www.alpha.com.
Primary SPI
Alternate SPI
Alternate SPI