Alpha Technologies PME Series - Manual (Page 17)

17 031-161-B0-006, Rev. F
2.0 Installation, continued
2.1 Pole-mounting, continued
2.1.1 Wooden Pole, continued
5. Secure the brackets to the pole using the 5/8" (15.9mm) machine bolts, washers,
and nuts.
6. Lift the enclosure onto the brackets. It might be necessary to rock and pull the
enclosure to properly seat it on the brackets.
7. Secure the enclosure to the brackets using the 3/8" x 3/4" (9.5mm x 19mm) hex
bolts.
8. Make sure all nuts and bolts are fully tightened and the fl anges of the brackets seat
in the wood.
9. The enclosure is now ready for the utility connection, power module, and batteries.
Fig. 2-1, PWE/PME Series Wooden Pole Mounting
Cable Power Out
Upper Mounting Bracket
Chassis Ground
Utility Power In
(with BBX)
Lower Mounting
Bracket
18" (457.2mm)
Nuts & Washers
PWE-3
5/8" (15.9mm) Bolts
Utility Power In
Lower Mounting
Bracket
Chassis Ground
Upper Mounting Bracket
18" (457.2mm)
Cable Power Out
PME
Nuts & Washers
5/8" (15.9mm) Bolts