Alpha Technologies BE-PWE - Manual

745-323-C0-001, Rev A
®
Alpha Technologies ® 1 of 2
Use EXTREME CAUTION when drilling into the enclosure. Verify what is behind the area you are drilling into.
If required, follow manufacturer’s instructions to power down the power supply and disconnect the battery
pack.
Pre-stamped dimples (half-shears) may mark the locations for drilling rivet holes. If you find these
marks, skip steps 1 and 2 and begin with step 3.
1. Center storm hood over the louvers and tape into place. Verify that covers do not interfere with
locks, lids, doors or logos. Verify that no structures, electrical boxes or wiring are behind the
area to be drilled. Reposition cover if needed.
2. Using a center punch, place a mark in the center of the rivet holes in the cover. Remove the
cover.
Set a drill stop collar 1/2” from end of drill bit to prevent damage to internal structures.
3. Use a #28 drill bit (9/64”) to drill out the rivet holes.
4. Use the rivets provided with the kit to install the covers.
Storm Cover
Enclosure
Rivet Gun Rivet
1/2"
P/N: 033-076-20 (with mounting brackets) Gray
033-077-20 (w/o mounting brackets) Gray
BE-PWE
1/2” drive hand drill Rivet gun with 1/8” nose piece
9/64” (#28) drill bit Tape Measure
Drill-Stop collar Vacuum to remove metal shavings from cabinet interior
Required
Tools:
The following instructions are for mounting the storm hoods on the BE-PWE enclosure:
STORM HOOD INSTALLATION FOR BE-PWE
WARNING
NOTE
CAUTION