Alpha Technologies High Wind Louver Cover Kits - Manual (Page 5)

745-442-C0-002 Rev. B 5
1.1 Safety Information
1.0 Introduction
1.3 Required Tools
Each kit will contain various quantities of:
• Sea-Foam Green or Gray Louver Covers (contact Alpha for additional colors)
• .129” Rivets
• Batting Material
• 1/2” drive hand drill
• 9/64” (#28) drill bit
• Drill-Stop collar
• Rivet gun with 1/8” nose piece
• Tape Measure
• Lint free rag
• Rubbing alcohol (or cleaning solvent)
• Scissors or razor knife
• Vacuum to remove metal shavings from interior of cabinet.
1.2 Parts List
A CAUTION presents safety information to PREVENT DAMAGE to EQUIPMENT
as the technician/user works on it.
CAUTION!
A WARNING presents safety information to PREVENT INJURY OR DEATH to the
technician/user.
WARNING!
A NOTE provides addtional information to help complete a specific task or procedure.
NOTE
The use of ATTENTION indicates specific regulatory/code requirements that may affect
the placement of equipment and installation procedures.
ATTENTION