American Expedition Vehicles ProCal Module Quick Reference Guide User Manual
American Expedition Vehicles For the car
AXLE RATIO
OPTIONS
ENGINE FUNCTIONS
RUNTIME FUNCTIONS
VIN RELEASE
1
1
1
1
1
2
2
2
2a
2b
2c
Set the last 6 based on preferred axle ratio using
the chart below.
Set the last 6 based on the chart below.
Set the last 6 using the chart below.
Set the first 3 DIP switches as shown.
Set the first 3 DIP switches as shown.
Set the first 3 DIP switches as shown.
Set the first 3 DIP switches as shown.
Set switches as noted above & the last 4 based on the chart below.
Set switches as noted above & the last 4 based on the chart below.
Set switches as noted above & the last 4 based on the chart below.
one-touch lane change
daytime running lamps
auto sway bar system
Set the first 3 DIP switches as shown.
By design, the Daytime Running
Lamps will only function with the
E-Brake in the OFF position and the
vehicle in gear (auto trans only). To
verify the function is correct and
desired mode is set, pull the vehicle
up to a reflective surface or have a
by-stander verify function. Please
take caution to keep the vehicle
under control at all times
Programming axle ratio is only required after physically changing the gears in the
differentials. There is no performance increase by adjusting this value to anything
besides what the vehicle has physically installed. Programming the incorrect ratio
will cause some vehicles to go into “Limp-In” mode.
The functions SET PEDAL and SET VIN are for new installs of the AEV JK Hemi
Conversion vehicles only. Failure to correctly finish these functions could leave the
vehicle in a temporarily inoperable condition. If the vehicle currently runs, these
functions should not be executed.
This mode will restore all settings to their original values and
release the VIN locked in the Procal for use in another vehicle.
*The engine must be running with the E-brake engaged before inserting the Procal.
Use the dimmer switch to adjust idle set point.
Runtime functions do not program any values and require the Procal to remain
plugged in during their use.