Antex Electronics SX-26 Digital Audio Adapter User Manual
Page 23
20
USING DOS DEMONSTRATION SOFTWARE
On the enclosed disk is the demonstration software for the SX-7,
SX-9, SX-11, SX-12a, SX-20, SX-22, SX-23e and SX-26 boards.
Filenames are as follows:
Driver Program
SX25.EXE
DOS Demonstration Program
ADG.EXE
To run the Demonstration Software:
1. Load the disk files into their own directory on your hard disk
using the DOS copy command (all files must be in the same
directory).
2. Install your mouse driver
3. Install the driver by running SX25.EXE
4. Run the demo ADG.EXE A=(I/O Address) I=(Interrupt)
ex. C>ADG A=280 I=2
(This is the default setting.)
5. At this point there should be a short pause as the board
initializes, then the demo environment should appear(Fig. 9).
Note: The left button of your mouse is to execute a command, the
right is to escape. You may also use the highlighted letter of the
command to access it directly from the keyboard.