Antex Electronics SX-33e Digital Audio Adapter - Manual (Page 18)

15
USING DOS DEMONSTRATION SOFTWARE:
On the enclosed disk is the demonstration software for the
Z1, Z1e, SX-3, SX-33 and SX-33e boards. Filenames are as fol-
lows:
Driver Program
Z1.EXE
DOS Demonstration Program
ADG.EXE
To run the Demonstration Software:
1. Load the included disk files into their own directory on your
hard disk using the DOS copy command (all files must be in
the same directory)
2. Install your mouse driver.
3. Install the Z1/Z1e/SX-3/SX-33/SX-33e driver by running
Z1.EXE.
4. Run the demo ADG.EXE A=(I/O Address) I=(Interrupt)
ex. C>ADG A=380 I=10 (This is the default setting.)
5.At this point there should be a short pause as
the board initializes, then the demo environ-
ment should appear(Fig. 6)
Note: The left button of your mouse is to exe-
cute a command, the right is to escape. You may
also use the highlighted letter of the command to
access it directly from the keyboard.