Astro Pneumatic 7300 Super Stand - Universal Rotating Parts Work Stand - Manual (Page 2)

7300 Assembly Instructions
PRIOR TO BEGINNING ASSEMBLY COMPARE PARTS TO PARTS LIST TO ASSURE THAT ALL PARTS ARE INCLUDED.
1) Attach pedal on front brace (#9) with nut (#9E) & bolt (#9D) to the bottom of the front brace.
Completely secure nuts & bolts. Remove temporary bolt at top of front brace and discard.
2) Align the holes on the wheel poles (#12) to the holes of the rear brace (#11). Attach the wheel poles to rear brace
with bolts (#11A), washers (#9C) and nuts (#9B). Completely secure nuts & bolts.
3) Attach wheels (#13) to wheel pole (#12). Position the wheels and large washer (#15) onto the
wheel pole (#12) and secure into place by inserting cotter pin (#14) into predrilled holes in the wheel pole.
Slightly spread ends of cotter pins to assure wheels will not fall off wheel pole.
4) Align the holes on the fixed pole, the holes on the brackets of the tray and the holes on the front brace (#9).
Attach with bolts (#9A), washers (#9C) and nuts (#9B). Do not completely secure.
5) Attach the rear brace (#11) to the fixed pole (#10) and tray (#16) by repeating procedure in step 4.
6) Completely secure nuts & bolts used in steps 4 and 5.
7) Press down pedal and insert the adjustable gear wheel (#5) into the hole at the top of the front brace
(#9) assuring that the predrilled hole on the adjustable gear wheel is facing up.
8) Insert stand pole (#6) onto the adjustable gear wheel (#5).
9) Insert stand pole (#6) through hole of rear brace (#11) and onto stand extension pole (#7).
Secure stand extension pole to stand pole by tightening screw (#7A) on extension.
10) Align the holes of the adjustable gear wheel (#5), stand pole (#6), plastic bushing (#6C), and washer
(#6B) and completely secure with nut (#6D) & bolt (#6A).
11) Handle (#8) to be used for moving stand for storage only.
Do not use to move stand while parts are mounted on stand.
NOTE : When mounting parts onto "Super Stand" select the appropriate suspend arm (#1) or prop arm (#2) for the job.
Do not begin work until you have checked and assured that parts are securely mounted onto "Super Stand"
7300
Super Stand
- Universal Rotating Parts Work Stand
page 2
ALWAYS WEAR ANSI APPROVED SAFETY GLASSES AND CLOTHING WHEN USING THIS UNIT.