ATAS PC PANEL - Manual

Installation Guide
The PC roof panel is available in three widths ( 11-1/4”, 12-5/8”,
and 15-1/4” with 1” Standing Seam or a 1” or 2” Batten Seam.
The panels are roll formed from 16 oz. copper, .032 and .040
aluminum and 24 ga. Metallic Coated steel, smooth or stucco
embossed. 22 ga. Metallic Coated steel is available, subject to
minimum quantity. The material has a KYNAR 500
® and/or
HYLAR 5000 ® quality finish, in 30 standard colors. The
minimum panel length is 3’-0”, the maximum is determined by
shipping considerations. Minimum recommended pitch is 3:12.
PC PANEL
PCB001 or PCB002
PCB900 Clip
Hex Head Screw
1-1/4”
3/4”
2”
(2) @ 1/8” diameter
Panel Seam & Lock
PSB900
Anchor Clip
Available in 24 ga.
Metallic Coated Steel
Use with PCB001 or
PCB002 Batten Seams
PCP110: 11-1/4”
PCP120: 12-5/8”
PCP150: 15-1/4”
5/8”
1”
3/8”
Snap-on Standing Seam
PCS114
1-1/2”
1-13/16”
2”
Snap-on 1” Batten Seam
PCB001
1-1/2”
1-13/16”
1”
Snap-on 2” Batten Seam
PCB002
PCS114
PSC900 Clip
2”
(1) @ 5/32”
Diameter
3/4” 3/4”
3/4”
1-1/2”
Panel Seam & Lock
PSC900
Anchor Clip
Available in 24 ga.
Metallic Coated Steel
Review and understand complete
guide before beginning installation.
This guide has been prepared as
suggested details to particular design
conditions. Each condition has certain limitations to
performance, aethetics or economics. Professionals
qualified to assess this information for a specific project,
should determine that the selection and installation are
made to their requirements. ATAS cannot assume any
responsibility for the actual selection and/or installation of
materials. The panels, flashings and trim shown in this
guide, illustrated over solid and plumb substrate, assume
that the structure has been designed and prepared in
accordance with local building codes.