Atec Agilent-4286A - Manual

1
HP 4286A RF LCR Meter
Specifications
Specifications describe the instrument's warranted performance over the temperature range of 0 ° C to
55 ° C (except as noted). Supplemental characteristics are intended to provide information that is useful in
applying the instrument by giving non-warranted performance parameters. These are denoted as typical,
typically, nominal or approximate. Warm up time must be greater than or equal to 30 minutes after
power on for all specifications.
Specifications of the stimulus characteristics and measurement accuracy are defined at the tip of
APC-7® connector of 3.5mm-7mm adapter connected to the test head.
Test Signal
Frequency Characteristics
Operating Frequency . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 MHz to 1000 MHz
A maximum of 10 frequencies can be programmed. An averaging factor can be set at each frequency point.
Frequency Resolution . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 kHz
Frequency Accuracy . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . < ±10 ppm @23±5°C
Source Characteristics
Definition of OSC level
• Voltage level : 2 × voltage level across the 50 Ω which is connected to the output terminal. (this level is
approximately equal to the level when a terminal is open)
• Current level : 2 × current level through the 50 Ω which is connected to the output terminal. (this level
is approximately equal to the level when a terminal is shorted)
• Power level : when terminating with 50 Ω .
OSC Level
Voltage Range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 mV
rms
to 1 V
rms
Current Range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 200 µ A to 20 mA
Power Range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . –33 dBm to +7 dBm
Technical Specifications
This literature was published years prior to the establishment of Agilent Technologies as a company independent from Hewlett-Packard
and describes products or services now available through Agilent. It may also refer to products/services no longer supported by Agilent. We
regret any inconvenience caused by obsolete information. For the latest information on Agilent’s test and measurement products go to:
www.agilent.com/find/products
Or in the U.S., call Agilent Technologies at 1-800-452-4844 (8am–8pm EST)
This literature was published years prior to the establishment of Agilent Technologies as a company independent from Hewlett-Packard
and describes products or services now available through Agilent. It may also refer to products/services no longer supported by Agilent.
We regret any inconvenience caused by obsolete information. For the latest information on Agilent’s test and measurement products go to:
www.agilent.com/find/products
Or in the US, call Agilent Technologies at 1-800-452-4844 (8am–8pm EST)
Discontinued Product—Support Information Only