Atec Aemc-5600 - Manual

Digital Micro-Ohmmeter Model 5600 (pdf) 03/03
Technical Assistance (800) 343-1391 www.aemc.com 1 of 5
The Digital Micro-Ohmmeter Model
5600 performs accurate, reliable low
resistance measurements with test
currents to 10A and resolution to 1m
Ω
.
The front end of the Model 5600
employs a 4-wire Kelvin configuration,
which eliminates test lead resistance
providing a measurement accuracy of
0.25%. A reverse polarity switch
compensates for the effect of DC
voltage interference on the accuracy
and permits reading averaging. A built-in
circuit filters against AC signals.
The large, easy-to-read LCD is 0.71"
(18mm) high and directly displays
resistance measurements in ohms with
an automatic decimal point. The LCD
also displays a “1” to indicate range
overload, and “–” to show a reversed
connection of the measurement leads.
Power is supplied by a long-life NiCD
battery with a built-in recharger
(110/ 220V).
The Model 5600 features automatic
shutoff after four minutes of non-use.
Four LEDs on the front panel indicate
measurement faults (open circuit,
blown fuse, etc.), thermal protection,
low battery and battery recharging.
For operator safety and instrument
protection, the Model 5600 is fuse
protected at the inputs. Two fuses,
accessible on the front panel, protect
against stored energy in inductive loads.
Enhanced internal circuitry gives
protection against possible inductive
kickback when the current is shut off.
A built-in thermal switch prevents the
micro-ohmmeter against overheating on
the 10A range when in continuous use.
The Model 5600 is housed in a sealed,
safety yellow field case with carrying
handle and a lid that may be removed
during testing if desired.
Digital Micro-Ohmmeter
Model 5600
T
Test Equipment Depot www.testequipmentdepot.com
99 Washington Street 800-517-8431
Melrose, MA 02176-6024 781-665-0780 FAX