Atec AEMC-6250 - Manual

10A Micro-Ohmmeter
Model 6250
The 10A Micro-Ohmmeter Model 6250
is a rugged, low resistance tester
designed for plant maintenance,
quality control in manufacturing and
field use. Utilizing a four-lead Kelvin
method of testing, the Model 6250
is one of the more accurate Micro-
Ohmmeters available, with results
within 0.05% accuracy.
Resistance measurements are
automatically calculated and
displayed, taking into account the
measurement value, ambient
temperature, reference temperature
and metal temperature coefficient.
Sample temperature can be manually
entered by the operator or directly
measured by the Model 6250 with
an external RTD temperature probe.
The Model 6250 is uniquely designed
to conduct tests on both resistive and
inductive material, with operator
selection directly from the front panel.
Three test modes are available and
automatically employed based on
this selection:
Resistive materials (i.e. ground
bonding, coatings, contact resistances)
are tested with an instantaneous test.
Simply press the test button – the
reading is taken and the test is
concluded.
Inductive materials (i.e. coils, trans-
formers, motor windings) are tested
with a continuous test. The test is
started and stopped by the operator
at the push of a button.
Auto test mode is designed for
multiple test points on resistive and/or
low inductance material. The test is
started at the press of a button. As the
operator moves the probe from one
point to another, the test is stopped,
the results are displayed and a new
test is started when the test probes
again make contact – no need to
press the test button! Residual voltage
is measured between tests to ensure
proper results. This test mode
continues until the operator presses
the button to conclude the testing.
The large, easy-to-read display shows
the resistance measurement, ambient
and reference temperatures, metal
type and test method, as well as alarm
conditions and memory utilization, all
in real time. Previously stored test
results can easily be called up for
review on the display or sent directly
to a printer or remote terminal.
Two programmable alarm set points
are available. Each can be either
active high or low and will sound an
alarm when tripped, further adding to
the ease of use by permitting quick
Pass/Fail measurements.
External trigger operation is available
through the communication port
allowing the test to be conducted
from a remote location.
The list of features and functions goes
on and on. The Model 6250 will be a
valuable asset for your bond testing,
coil and contact testing as well as
coatings and connector or any other
low resistance testing application.
10A Micro-Ohmmeter Model 6250 (pdf) Rev. 04 0306
Technical Assistance (800) 343-1391 www.aemc.com 1 of 5