Atec Chroma-19572 - Manual

The Chroma 19572 provides high current testing
of ground continuity between chassis and power
cord ground on a wide variety of electrical products
and appliances. The unit is designed for maximum
flexibility and operation convenience in mind.
The simple front panel of the tester requires less
effort to operate. The Digital display and user
friendly control allow test parameters and limits to
be set easily without activating the high voltage.
The instrument can be put on line rapidly. It can
provide operators useful measurements with little
to no training.
The use of a high current AC test provides a better
simulation of how the ground on the device would
perform under actual conditions if the motor or
wiring was to short to ground. This verifies that the
grounds in the device can handle 30 or 40 Amps
until a circuit breaker trips or fuse blows. Most
European standards such as TUV, CE, VDE, UL and
CSA recommend this type of testing. In contrast,
the ground continuity test that is provided as part
of most hipot testers just checks to make sure there
is a connection.
■ TUV approved
■ CE certified
■ High current ground continuity testing up
to 45Amps
■
Resistance measurements from 0.1mΩ
up to 45Amps
■
Large LCD display (240 x 64dot matrix)
Can supply great view of test result and
setting functions
■
Programmable high and low resistance
limits
■
Adjustable test time from 0.5 to 999
seconds or continue
■
Built-in calibration via software
■ Automatic offset of lead resistance
■ Built-in resistance compensation function
■ Compatible with the 19070 series
Hi-pot Tester
■
Digital readout of current, resistance and
test time
■
Front panel lockout
■ Remote control
■ 10 steps or 99 groups for total 500
memory locations
■
Beeper on/off
■ Easy to use
MODEL 19572
High and Low Resistance Limits
The 19572 offers a resistance measurement range
from 0.1 to 510mΩ.The high and low resistance
limits with pass/fail indication are also user
programmable.
Remote Control
The 19572 can be incorporated into an automated
manufacturing environment with remote start and
GO/NOGO results output through the rear panel PLC
interface.
The 19070 Series Hipot Tester Compatibility
The 19572 can be used alone or connected to
Chroma 19070 Series for complete product test
with the push of one button. When the 19572 has
completed a continuity test, with pass indicated, it
can remotely start the 19070 Series for a hi-pot test
in sequence.
Built-In Calibration Via Software
The front panel display of an operation promoted
calibration routine requires no internal adjustments.
GROUND BOND TESTER
MODEL 19572
Model 19572
Ground Bond Tester
Key Features :
GPIB RS-232