Atec Agilent-DSA90404A - Manual (Page 21)

21
E2678A 12-GHz differential
socket probe head
can be used to
measure either differential or single‑ended
signals via a plug‑on socket connection.
E2676A 6-GHz single-ended
browser is the best choice for general‑
purpose probing of single‑ended signals
when the small size of the probe head is
the primary consideration.
E2675A 6-GHz differential
browser is the best choice for general‑
purpose trouble shooting of differential or
single‑ended signals with z‑axis compliance
and variable spacing from 0.25 ‑ 5.80 mm
(10 ‑ 230 mills).
N5382A 13-GHz high-bandwidth
differential browser
provides
maximum bandwidth for hand‑held or probe
holder use. Variable spacing from 0.2 to 3.3
mm (8 to 130 mills).
Six different InfiniiMax probe amplifiers from 1.5 GHz to 13 GHz are available for matching
your probing solution to your performance and budget requirements. The 1168/69A
InfiniiMax II amplifiers offer the highest bandwidth and the lowest noise floors. The
1134/32/31/30A offer a more cost efficient solution and wider dynamic range.
N5450B InfiniiMax extreme
temperature extension cable
provides extra reach into environmental
chambers.
N5380B 13-GHz high-bandwidth
differential SMA probe head provides
maximum bandwidth for SMA‑fixtured
differential pairs.
N2880A In-line Attenuator Kit
allows you to increase the dynamic range
and the offset range of the InfiniiMax probe
without affecting the bandwidth.
N2881A DC Blocking
Capacitors can be used to in series
with the N2880A InfiniiMax in‑line
attenuators to block out unwanted DC
components of the input signal up to 30V.
N2884A Differential Fine-wire
Probing Tip InfiniiMax differential
fine‑wire probing tip is a high fidelity, high
bandwidth solution for probing an active IC.
N2887A InfiniiMax Soft touch
Pro Probe Adapter adapts from
the Agilent Pro Series (36 ch) Soft touch
connectorless logic analyzer foot print to
the Agilent InfiniiMax I & II series probe
amplifier input connectors
N2888A InfiniiMax Soft touch
half-channel Probe Adapter
adapts from the Agilent half‑channel
(18 ch) Soft touch connectorless logic
analyzer foot print to the Agilent InfiniiMax
I & II series probe amplifier input connectors