Atec Agilent-60502B - Manual

6050A
6051A
6060B
6063B
60501B
60502B
60503B
60504B
60507B
38 AGILENT dc ELECTRONIC LOADS
GPIB control of current, voltage, and resistance
GPIB readback of current, voltage, and power
Built-in pulse waveform generation with programmable
amplitude, frequency, duty cycle, and slew rate
Continuous and pulse modes
Full protection from overcurrent, overvoltage, overpower,
overtemperature, and reverse polarity
Electronic calibration
Trigger for external synchronization
Analog voltage control in constant
current mode
Parallel units in constant current mode for higher power
Remote voltage sense in constant voltage mode
Loads available for up to 240 V
Standard three-year warranty
VXIplug&play drivers
Agilent dc Electronic Loads
Agilent dc electronic loads are ideal for the test and evaluation of
dc power sources and power components and are well-suited for
applications in areas such as manufacturing, research and devel-
opment, and incoming inspection.
The Agilent One-Box Solution
Agilent single-input loads and load mainframes are equipped with
standard GPIB interfaces. This built-in IEEE-488 interface allows
complete control of all load functions as well as readback of input
voltage, current, power, and detailed operating status. Each stand
alone load or load module also includes programming inputs that
allow control of load current via an analog voltage. Other system
features contributing to the one-box solution concept are internal
voltage and current monitors and an internal transient generator
with programmable amplitudes, frequency, duty cycle, and slew
rate. The one-box solution saves space, cost, and time while
making these dc electronic loads easy to integrate into automated
test systems.
Agilent dc electronic loads are optimized to address a broad
range of dynamic loading applications. They are specifically
designed for stability in applications where fast transients are
applied to the load inputs, such as during dc power supply startup
characterization or transient response testing. Dynamic load per-
formance can be further tailored to specific application needs with
the programmable slew rate feature.
Fully-Compatible Operation
These dc electronic loads respond to instructions from the
industry-standard SCPI command set. Moreover, the features of
these dc electronic loads are fully compatible with one another.
For example, test programs developed for 6060B 300 W single-
input electronic load or 60502B 300 W single-input load module
are interchangeable.
The dc electronic load family is also fully compatible with the
59510A relay accessory (see page 33). The 59510A provides physi-
cal isolation of the dc electronic load from the device under test or
any other test instrument by switching power and sense leads.
Capable of switching up to 60 A and 200 Vdc, the 59510A
can be controlled by rear-panel signals on the electronic load.
Battery Testing
The 6050A Option J10, 6051A Option J10 and 6060B Option J10
electronic loads are modified for battery testing. These products
provide tri-level pulse loading, to simulate accurate conditions on
batteries. They also feature a programmable minimum battery
voltage threshold (measured at load terminal). If the voltage of the
battery under test falls below this threshold, the load will automat-
ically turn off.
6060B and 6063B
6050A with 60500 series
modules
6051A with 60500 series
modules
A
B
C
D
G
dc
Electronic
Loads
Recycled Equipment (410)685-1997 www.recycledequipment.com email: [email protected]