Atec Agilent-8564E - Manual

Unless noted, all specifications describe the instru-
ments’ warranted performance under the following
conditions: 5-minute warm-up from ambient condi-
tions, autocoupled controls, digital display, IF ADJ
ON, REF LVL CAL adjusted, SECOND IF OUTPUT
and 1ST LO OUTPUT terminated in 50
Ω
. After a
30-minute warm-up, and over a temperature range
of 20 °C to 30 °C, the preselector does not have to
be peaked at each signal of interest; under these
conditions factory preselector peak values are suf-
ficient to meet all specifications. Typical perform-
ance is nonwarranted. Supplemental characteris-
tics are denoted by “nominal” and “approximately”;
these constitute nonwarranted functional perform-
ance information derived during the design
process and are not tested on a continuing basis.
Agilent 8560 E-Series
Spectrum Analyzers
Data Sheet
8560E 30 Hz to 2.9 GHz
8561E 30 Hz to 6.5 GHz
8562E 30 Hz to 13.2 GHz
8563E 30 Hz to 26.5 GHz
8564E 30 Hz to 40 GHz
8565E 30 Hz to 50 GHz
DATA
MARKER CONTROL
INSTRUMENT STATE
1ST LO
OUTPUT
VOLUME PROBE
POWER
CAL
OUTPUT
IF
INPUT
INPUT 50 Ω
9 kHz - 50 GHz STEP
8565E
SPECTRUM ANALYZER 9 kHz - 50 GHz