Atec Fluke-990DSL - Manual

Technical Data
990DSL CopperPro
™
Copper Loop Qualification Tester
The CopperPro family of loop testers from
Fluke Networks provides all technicians
working in the outside plant a full
complement of testing, fault locating and
qualification capabilities in a single, rugged,
handheld test set. CopperPro is easy to use.
Fast. And it offers more capability than any
other single loop test set.
Installation and maintenance
CopperPro makes fast work of installing and
maintaining service. The one-button POTS
AutoTest helps you quickly document status
before and after work is complete. And all
the basic tests you expect are there, as
well – AC and DC voltage, loop current,
circuit noise, balance, leakage and Caller
ID/ANI. Verify DSLAM and modem on ADSL
lines. Make fast work of loss and slope tests
with its automated dial-up tests. Even a dial
set with phone number storage is built in.
Cable construction and repair
Use CopperPro’s unique TDR AutoTest to
both locate and identify faults. But that’s
not all. Find shorted or open pairs fast.
Count and locate load coils. Locate high-
resistance faults precisely, no matter the
cable make up. Step-by-step instructions
make set up a breeze.
16 test sets in one
CopperPro packs all the test, analysis
and troubleshooting capabilities an
OSP technician needs into one
integrated handheld tool for a new
view of your local loop:
1. Digital Multimeter — AC/DC
Voltage, Resistance
2. Opens Meter — measure
capacitive length of pair
3. RFL Meter — locate shorts,
crosses or grounds
4. Noise Meter — VF & WB,
Gaussian & Impulse
5. Time Domain Reflectometer —
precisely locate and identify faults
6. Dial Set — set up or monitor
calls
7. Leakage Tester — “punch”
through resistance faults not
detected by other tests
8. Ammeter — test DC loop current
9. Loss Meter — VF & WB. Measure
signal loss over a pair in voice or
wideband frequency ranges
10. VF & WB Precision Signal
Generator — generate precisely
controlled signals in single tones,
swept sets or composite signals
11. Tracing Tone Generator — iden-
tify pairs
12. ANI & CID Tester — identify
telephone numbers and verify
proper Caller ID operation
13. ADSL Connectivity Tester —
verify DSLAM and customer
modem functionality
14. ADSL and Special Services Pair
Qualification Set — prequalify
pairs for up to 12 digital services
15. VF and WB Longitudinal Balance
Meter — identify and prevent
noise problems
16. Power Harmonics Analyzer —
quickly track down tough noise
problems
The standard for all copper loop testing applications –
Network SuperVision
™ for your local loop
Pair up with Terminator for
fast, easy, one-tech-out
terminating testing
With the companion Terminator, qualifying
pairs for voice or data services is easy.
In fact, it’s the only solution that meets
manufacturers’ requirements for HDSL2 and
HDSL4 qualification –
including loop
attenaution – with
one technician in
less than two minutes.
Together, they’re a
proven way to re-
duce failure frequency,
wasted dispatches
and rebates.