Atec Haefely-pim400-410-430 - Manual

PIM 400, PIM 410
PCD430
UL 1449 IMPULSE TEST SYSTEM
Top-down: Controller, PIM 110, PIM 400 & PIM 410
impulse modules, PCD430 coupling network
To be used for transient voltage surge
suppressor testing of:
n Surge Current Tests
n Transient Voltage Surge
n Duty Cycle.
Using combination wave impulses for 50 and
60Hz power circuit applications.
Transient Voltage Surge Suppressors are fitted
on the load side of domestic and commercial
power outlets to protect electrical and electronic
equipment from the effects of lightning surge
pulses.
Applications are for the testing of single and
three phase protection devices of the following
categories:
n Permanently connected
n Cord connected
n Direct plug-In
A suitable CDN is required as the tests are
performed with the TVSS energized
ONE SOLUTION
for :
þ UL 1449 Table B1.1 (Appendix B)
þ add a PIM 110 for full ANSI C62.41
FEATURES
n Impulse voltage up to 7kV
n 3000A impulse (2 ohm)
n 500A impulse (12 ohm)
n 100kHz Ring wave (12 & 30 ohm)
n Oscilloscope Impulse monitors
n 10s impulse repetition @ 6kV
n Automatic polarity switching
n Automatic impulse switching
n 32A 3 phase CDN @ 600V/60Hz
n impulse defined at CDN output
n allowable fault current > 200A
n synchronization with each phase
n Remote control using WinFEAT&R
n Supplied to ISO 9001
BENEFITS
n Fully automatic waveform switching
n Reproducible and reliable test results
n Fault current through CDN > 200A