Atec Rohde-Schwarz_FSL Series - Manual (Page 32)

R&S ® FSL Spectrum Analyzer Version 09.00, December 2008 32
R&S
®
FSL-K92 WiMAX™ IEEE 802.16 OFDM analysis
(IEEE 802.16-2004, IEEE 802.16-2004/Cor1-2005,
IEEE 802.16e-2005, P802.16-Rev2/D3 WiMAX™)
The specifications of the R&S ® FSL-K92 option are based on the data sheet of the R&S ® FSL spectrum analyzer.
Specifications apply under the following conditions: 30 minutes warm-up time at ambient temperature, specified environmental
conditions met, calibration cycle adhered to, and all internal automatic adjustments performed. "Typical values" are designated with
the abbreviation "typ." These values are verified during the final test but are not assured by Rohde & Schwarz. "Nominal values" are
design parameters that are not assured by Rohde & Schwarz. These values are verified during product development but are not
specifically tested during production.
Frequency
RF input
R&S ® FSL3 50 MHz 7 to 3 GHz
R&S ® FSL6 50 MHz 7 to 6 GHz
Frequency range
R&S ® FSL18 50 MHz 7 to 18 GHz
Frequency setting frequency, channel number
model serial number or lower
R&S ® FSL3 8 100703
R&S ® FSL6 8 100604
R&S ® FSL3 100945
R&S ® FSL6 100759
1.44 MHz to 20 MHz
model serial number or higher
R&S ® FSL3 8 100704
R&S ® FSL6 8 100605
R&S ® FSL3 100946
R&S ® FSL6 100760
1.44 MHz to 32 MHz
Sampling rate F
s
R&S ® FSL18 1.44 MHz to 32 MHz
Level
Level range RF input
60 dBm to +30 dBm
Level setting auto, manual
Signal acquisition
Supported standards IEEE 802.16-2004 OFDM,
IEEE 802.16e-2005 OFDM
P802.16-Rev2/D3 OFDM
Capture length 24 µs to 15.6 ms
Gate length 24 µs to capture length
Number of analyzed bursts 1 to 10922 bursts
power versus time, EVM versus symbol,
EVM versus carrier, frequency error
versus preamble, phase error versus
preamble, constellation versus symbol,
constellation versus carrier, spectrum
flatness, spectrum flatness difference,
group delay, bit stream, burst summary capture length 9
FFT spectrum, CCDF capture length or gate length
Result length
result summary capture length 9 or 1 to 10922 bursts
Burst length number of data symbols automatically
detected, manually adjustable 1 to 2425
spectrum mask 2.5 ms to 16000 s, auto Sweep time
adjacent channel power ratio (ACPR) 10 ms to 16000 s
Sweep count 1 to 32767
Trigger modes RF input free run, external, power
7 5 MHz to 50 MHz with restricted functionality depending on bandwidth (power trigger, auto level, IF overload).
8 With tracking generator.
9 Max. 2000 bursts per capture buffer.