Atec Yokogawa_FX100 Series - Manual

NO .
STYLE
MODEL SUFFIX SUPPL Y FREQ U ENCY
10Base-T
RS-422A/485 FG SG S D B S DA R D B R DA
144.3 (5.68)
151.5 (5.96) (0.95)
24.1
(2.30)
58.4 175 (6.89) 9.4
7.5
(0.37)
(min. space for mounting)
(0.30)
(dimension after mounting)
136.5
+0.4 0 (5.37)
144.3 (5.68) 151.5 (5.96)
(approx. inch)
Unit : mm
2 to 26 (panel thickness)
Ethernet
Power Supply
Terminal
Option Terminal
Input Terminal
1 to 12ch
RS-232 or RS-422A/485
Bulletin 04L20A01-00E
FX103/FX106/FX112
Paperless recorder
NOTICE
● The mounting hardware is attached on both sides or at the top and
bottom (2places) for panelmounting.
● See the general speelfication sheet (GS 04N03A01-00E) for the panel
cutout for
side by side or top-and bottom mounting.
www.yokogawa.com/tm/
... and subscribe to “Newswave,”
our free e-mail newsletter
*1: /A1, /A2, /A3 cannot be specified together.
*2: /C2, /C3 cannot be specified together.
*3: If /F1 is specified, /A3 cannot be specified.
*4: If /PM1 is specified, each /A3, /R1, and /M1 cannot be specified.
*4: If /PM1 is specified, /A2 and /F1 cannot be specified together.
In case that Modbus master function is utilized, either /M1 or /PM1 must be specified.
The TCP/IP software used in this product and the document for that
TCP/IP software are based in part on BSD networking software, Release 1 licensed from The
Regents of the University of California.
• Ethernet is a registered trademark of XEROX Corporation.
• Modbus is a registered trademark of AEG Schneider
• Other company and/or product names are registered trade mark of their manufactures.
Subject to change without notice.
[Ed : 01/b] Copyright ©2003
Printed in Japan, 310(YG)
YOKOGAWA ELECTRIC CORPORATION
Network Solutions Sales Business Div./Phone: (81)-55-243-0309, Fax: (81)-55-243-0397
E-mail: [email protected]
YOKOGAWA CORPORATION OF AMERICA Phone: (1)-770-253-7000, Fax: (1)-770-251-2088
YOKOGAWA EUROPE B.V. Phone: (31)-33-4641806, Fax: (31)-33-4641807
YOKOGAWA ENGINEERING ASIA PTE. LTD. Phone: (65)-62419933, Fax: (65)-62412606 RS-12E
FX100 Specification
Input section
Measurement points: FX103 3 (three) channels
FX106 6 (six) channels
FX112 12 (twelve) channels
Measurement interval: FX103 250 ms
FX106, FX112 1s, 2s
Input Types DCV:20mV, 60mV, 200mV, 2V, 6V, 20V, 50V
TC: R, S, B, K, E, J, T, N, W, L, U, WRe
RTD: Pt100, JPt100 (Pt1000: Optional)
DI:
voltage input (TTL), contact input
DCA:with external shunt register
Simple Calculation: Differential, linear scaling, square root
Maximum allowable input voltage:
± 10 VDC (continuous) for less than 200mVDC range, TC, RTD, DI
ranges
± 60 VDC (continuous) for more than 2 VDC range
Maximum common mode noise voltage:
250 Vrms AC (50/60Hz)
Maximum noise voltage between channels:
250 Vrms AC (50/60Hz)
Display
Display: 5,5“ TFT color-LCD
Display types: Trend, bar graph, digital, overview, historical,
information (alarm, message, memory)
Language: English, French, Germany, Japanese
Data Storage Function
Internal memory: Flash memory
External media: One of the following external media options can be specified:
- None, - 3,5“ floppy disk, - compact flash memory card (32MB-512MB)
Saving method: Automatic saving or manual saving
Data type: Display data, event data
Data format: Binary format
Alarm Function
Number of levels: 4 levels per channels
Type of alarm: Higher/lower limits, differential higher/
lower limits, rate-of-change rising/falling limits
Construction
Dimensions: 144(W) x 144(H) x 234(D) mm
Weights: FX1xx-0: approximately 2.2 kg
FX1xx-1: approximately 2.5 kg
FX1xx-4: approximately 2.3 kg
Front panel: Water and dust proof (based on IEC529-IP65, except external icing
test, except for side-by-side mounting)
Power Supply
Rated voltage: 100 to 240 VAC
Rated frequency: 50/60 Hz
Power consumption: normal 22 VA, maximum 35 VA
Safety and EMC Standards
Safety standards: Certified by CSA22.2 No.1010-1, UL61010B-B complies with
EN61010-1
EMC standards: Complies with EN61326-1
Optional Pulse Input Functions (/PM1)
Number of channels: 3 for pulse, and 5 for remote controlling
Applicable frequency: Up to 100 Hz
Minimum pulse width detection:
Low (close), high (open) : more than 5ms
Optional Relay Output (/A1, /A2, /A3)
Number of outputs: 2,4,or 6 points; energized/
di-energized, hold/non-hold, AND/OR
Optional Serial Communication functions (/C2, /C3)
Connection: EIA RS232 (/C2) or RS-422-A/485 (/C3)
Protocols: Yokogawa private protocol
Modbus function: MODBUS RTU MASTER/ SLAVE
Optional Ethernet Communication functions (/C7)
Connection: Ethernet (10Base-T)
Functions: E-mail notification, Web-server, FTP function
Optional Mathematic Functions (/M1)
Number of channels: Up to 12 channels
Operations:
General arithmetic operations:
Four arithmetic operations, square root, absolute, common
logarithm, exponential, power, relations, logic operations.
Statistical operations: Average, minimum, maximum, and summation
Constant:
Available (up to 30 constants)
Digital data input via communication:
Up to 12 data
Report function:
Type:
Hourly, daily, hourly+daily, daily+weekly, daily+monthly
Operation: Average, maximum, minimum, summation
Data format: ASCII
Optional Remote Controlling Functions (/R1)
Number of channels: 8 points
Operable items: Memory start/stop, computation start/stop, computation data reset,
alarm acknowledgement, event file external trigger, message writing,
load setting, time setting, snapshot.
FX103
FX106
FX112
External memory -0
-1
-4
Display Language -2
Option /A1
/A2
/A3
/C2
/C3
/C7
/F1
/M1
/N2
/N3
/PM1
/R1
FX100(3ch)
FX100(6ch)
FX100(12ch)
None
FDD (3.5 inch, 1.44MB)
Compact flash memory card(32MB)
English (German/French)
Alarm output 2 points * 1
Alarm output 4 points * 1
Alarm output 6 points * 1
RS-232 communication interface * 2
RS-422-A/485 communication interface * 2
Ethernet(10BASE-T) communication interface
FAIL/memory end output * 3
Mathematical function (with report function)
3 legs isolated RTD
Pt1000 Ω input
Pulse input 3 points, remote control 5 points (including Mathematical function )* 4
Remote control 8 points
Model Description Suffix
code
Option
code