Atec Solar-Electronics-7334-1 - Manual

HISTORICAL NOTE
The AT-205/URM-6 Loop Sensor described in
Test Method RE01 of MIL-STD-462 is one of the
antennas designed for use with the Navy
AN/URM-6B and Stoddart NM-10A receivers.
These were the low frequency EMI meters that,
in 1948, initiated the emphasis on EMI by the
military departments and created the technical
discipline we now know as Electromagnetic
Compatibility.
DESCRIPTION
The Solar Type 7334-1 Loop Antenna has been
designed as a substitute for the AT-205/URM-6
antenna and is a replacement for Eaton Model
94607-1. It uses 36 turns of wire on a 5.25"
(13.3 cm) diameter form enclosed in an electro-
static shield as described in paragraph 5.2.1 of
MIL-STD-461A.
The Type 7334-1 is equipped with an epoxy-glass
base plate which serves as a spacer to enable the
user to place the loop at exactly 7 cm from the
face of the item under test as required by test
procedure RE01 of MIL-STD-462.
APPLICATION
Connection to the loop is through a BNC connec-
tor which enables coaxial cabling to the EMI
receiver. The loop is supplied with a correction
factor graph showing the values in dB which
must be added to the reading of a 50 ohm EMI
meter to obtain answers in either dB/µV/m
or dB/pT. The correction factor decreases as
frequency increases from 30 Hz up to approxi-
mately 15 KHz, where the factor levels off and
remains relatively constant up to 5 MHz.
The Type 7334-1 Loop Antenna is required by
Test Method RE01 in Parts 2 through 6 of
MIL-STD-461C and RE101 of MIL-STD-461D. These
portions of the specification require magnetic
field emission tests of cables, equipments,
systems and sub-systems installed in, or used in,
all phases of military vehicles, ships, submarines,
aircraft (including helicopters), spacecraft, or
ground-based operations.
TEST METHODS RE01 and RE101
The Type 7334-1 Loop Antenna is positioned
7 cm from the face of the equipment under
test with the plane of the loop parallel to the
equipment face. The best position to begin with
is opposite or near a joint or seam.
The associated EMI meter is then scanned over
the range 30 Hz to 100 KHz searching for
emissions. At the frequencies where emissions
are found, the loop antenna is moved about the
surface seeking the strongest emission level.
When a strong signal is detected, the loop is
oriented on its axis for a maximum reading.
This procedure is repeated for all surfaces of the
equipment under test. Although the specification
is not clear on the point, it appears to indicate
that all six sides (including the bottom) of an
equipment must be tested in this manner.
When testing cables, the loop antenna is placed
7 cm from the cable with the plane of the loop
parallel to the cable. The non-metallic base plate
of the Type 7334-1 Loop Antenna provides a
convenient means for establishing the correct
7 cm distance.
TYPE 7334-1 LOOP ANTENNA
for RE01 and RE101 magnetic emission tests
47