Atec Tektronix-1502 - Manual (Page 75)

TM 9-4935-601-14-3&P
Figure 5-37. Detail of front panel jacks. Figure 5-38. Detail of X-Y Module thumbscrews
d. JACK, TIP: RED MPL Item 3-6.
e. Procedure
1. Clean the mating surface of the Subpanel with isopropyl alcohol.
2. Align the Front Panel over the Subpanel and insert one of the jacks in its respective position.
3. Form a bead of No. 3144 sealant around the Jack/Subpanel interface as shown in Fig. 5-37.
4. Use the supplied washer and nut to secure the jack in position.
5. Repeat steps 3 and 4 for the remaining five jacks.
32. Preparation of the Thumbscrews that are used for securing the X-Y Output Module (see Fig. 5-38)
a. PACKING (O-ring) MPL Item 3-11.
b. PIN, (shaft) MPL Item 3-8.
c. KNOB MPL Item 3-7.
d. Procedure
1. Insert one of the Pins (shaft) through the Front Panel and Subpanel.
2. Apply G-661 lubricant to the O-ring.
3. Position the O-ring on the shaft as shown in Fig. 5-38.
4. Place the knob on the shaft and tighten the setscrew.
5. Repeat procedure for the second thumbscrew.
@ FEB 1980
5-19