Atec Teseq-ProfLine_2103 - Manual

A d v a n c e d Te s t S o l u t i o n s f o r E M C
System
ProfLine 2103 is an accurate and fl exible single phase system designed to measure harmonics and fl icker
in accordance with IEC 61000-3-2 and IEC 61000-3-3, supporting testing on products consuming up to
11 Amps rms and 92 Amp peak @230 Vac. The system is supplied complete with a stable, accurate,
programmable 3 kVA power source. The ProfLine 2103 system is therefore ready to measure and record
any harmonics and fl icker created by the EUT. A wide range of higher power AC source systems are
available from Teseq, please see ProfLine 2105, 2115, 2130, 2145 datasheets for suitable systems at
higher power or for 3-phase operation.
Measurements are made using precision, no burden, active hall-effect current transformers connected
via a dedicated cable to a multichannel fast Data Acquisition Card (DAQ) fi tted inside a PC. One voltage
and three current measuring channels are used to make simultaneous measurement of both current
and voltage. Calculations are made using dedicated Teseq software (WIN 2100) to determine harmonics
(classes A-D), inter-harmonics, fl icker, dc, dt, dmax, Pst, Plt, inrush current and 24 x dmax.
Impedance
Measurement of fl icker requires a fi xed, stable source impedance as specifi ed in IEC 61000-3-3 (0.24 Ω
+ j0.15 Ω in the line and 0.16 Ω + j0.1 Ω in the neutral). The precision power source (NSG 1007-3) supplied
as part of the system is able to accurately simulate this impedance by careful control of the relation-
ship between voltage and current. This eliminates the need for a costly physical impedance. However,
hardware lumped impedances are available from Teseq, see options list.
Power quality measurement
The power source (NSG 1007-3) supplied as part of the ProfLine 2103 system is able to perform tests in
conformance to a number of immunity standards. IEC 61000-4-13 (immunity to harmonics and interhar-
monics), IEC 61000-4-14 (voltage fl uctuations), IEC 61000-4-17 (ripple on DC) and IEC 61000-4-28 (variation
of power frequency). Additionally it can also perform pre-compliance testing to IEC 61000-4-29 (voltage
dips, interrupts and variations on DC supply) and IEC 61000-4-11. With the addition of further options
IEC 61000-4-8 (power frequency magnetics) and fully compliant IEC 61000-4-11 (voltage dips, interrupts
and variation on AC supply) can be implemented.
3 KVA 1-PHASE HARMONICS AND FLICKER
MEASURING SYSTEM
PROFLINE 2103
Low cost system for small DUTs
Complete test system including
clean power source
Simulated flicker impedance,
no need for expensive physical
impedance