atwood Levelegs System (towable RV's) - Manual (Page 3)

3
SYSTEM PROTECTION FEATURES
Nine Cycle Maximum
• The controls will shut off for 15 minutes any time nine (9) full
retractions occur in less than 30 minutes.
• When this occurs, all four-system status lights blink off and on.
• This sequence can be overruled by turning the ignition off, then back on.
Low Voltage Protection
• If the voltage falls below 11.5 VDC, leveler operation will cease
and the low voltage LED will flash.
• Controls will be inoperable until battery voltage climbs above 13
VDC, at which time leveling functions will resume.
Front Too Low
• Should the angle of front of the RV drop below level the system
will stop the Landing Gear from retracting and possibly setting
the front of the RV on the ground.
Manual Override
• To Manually Extend or Retract Leveler, use a 1/2˝ socket on Drive
Nut on end of motor ( FIG 11).
Rotate nut counter clock-wise (looking from bottom end of nut
[
FIG 11) to extend leveler.
NOTE : It takes 500 revolutions of nut to extend/retract leveler 1˝.
ƽ
CAUTION
PERSONAL INJURY/PRODUCT DAMAGE
• Battery operated drills, 9.6V to 18V, are powerful. Hold drill with both
hands to protect your wrist. Keep loose clothing and body parts away
from drill as the reaction torque from the drill may cause it to kick back.
• Refer to your drill manufacturer’s operation manual.
• Do not over -extend or over-retract levelers. Each leveler has built-in
stops. Excessive force applied against the stops will cause damage.
• When manually overriding the leveler do not use pneumatic tools to
operate any leveler. They can over-extend or over-retract the leveler.
• If the motor will not extend/retract the leveler and the motor is making
a ratcheting sound (clutch slipping), do not use the manual override.
Immediately contact an Atwood Service Center and have leveler
replaced. Do not use the leveler until replaced.
MAINTENANCE
1. Internal parts of leveler are permanently lubricated at the factory
and do not require any further lubrication.
2. If it is not possible to get levelers to operate freely, replace leveler.
3. Should problems or questions arise, contact your dealer, camper
manufacturer, or Atwood Consumer Service Department
866-869-3118.
ATWOOD LIMITED WARRANTY
Atwood Mobile Products warrants to the retail owner and subject to the
below mentioned conditions, that this product will be free of defects in
material or workmanship for a period of two years from the original date of
purchase. Atwood’s liability hereunder is limited to the replacement of the
product, repair of the product, or replacement of the product with a recon-
ditioned product at the discretion of the manufacturer. This warranty is void
if the product has been damaged by accident, unreasonable use, neglect,
tampering or other causes not arising from defects in material or workman-
ship. This warranty extends to the original owner of the product only and is
subject to the following conditions:
1. For two (2) years commencing with the date of purchase, Atwood will
provide the replacement or repair of any Hardware System and
Components that are found to be defective by Atwood in material or
workmanship.
2. In the event of a warranty claim, the original owner must contact
the Atwood Consumer Service Department, 1120 North Main,
Elkhart, IN 46514 USA. Phone: (574-264-2131). Warranty Claim
Service must be performed as approved by the Atwood Consumer
Service Department. Warranty replacement hardware systems and com-
ponents or parts will be furnished freight prepaid. Labor cost to repair or
replace will be limited to the amount of the original purchase price of the
systems and components. The replaced warranty products or parts
become the property of Atwood Mobile Products and must be returned
to the Atwood Consumer Service Department freight prepaid, unless
prior arrangements have been made.
3. This limited warranty is valid only when the product is applied, installed,
maintained and operated in accordance with this Atwood Installation
Maintenance and Operating Manual. Any deviation from these recom-
mended specifications must be approved in writing by Atwood.
4. ANY IMPLIED WARRANTIES arising by way of State Law, including any
implied warranty of merchantability and any implied warranty of fitness for
a particular purpose are limited in duration to the term of this Limited
Warranty. Atwood makes no further warranty of any nature beyond this
Limited Warranty. No person has authority to enlarge, amend or modify this
Limited Warranty.
5. Any action to enforce this warranty shall not be commenced more than
one (1) year after the expiration of this warranty. 7.21.07
EMERGENCY STOP ANY LEVELER ACTIVITY
PRESS ANY BUTTON ON KEY PAD
Unhooking From Tow Vehicle and Leveling RV
1. Park on solid ground without obstructions.
Chock wheel and warn persons to stand clear of RV.
2. Do not extend slideouts until RV is leveled.
3. Switch Activation Switch ON.
4. Turn on Key Pad
ON
5. Auto extend Landing Gear
(Front
Legs)
EXT/ALL/FRONT
6. Set preferred King Pin height for
unhooking
hitch
7. Detach Tow Vehicle from RV and
move to safe distance.
8. Auto extend rear levlers and level RV.
AUTO
9. Once RV is level, turn unit off and
ON
Activation Switch OFF.
Hooking Up To Tow Vehicle Retraction of Levelers
1. Retract slide rooms and
warn all persons to stand clear of RV
2. Switch Activation Switch ON.
3. Turn on Key Pad
ON
4. Auto retract the rear levelers RET/ALL/REAR
5. Set King Pin height (per hitch mfg.’s
EXT/FRONT
recommendations) for proper
RET/FRONT
hitch connection
6. Position tow vehicle, connect hitch
and connect trailer wiring harness
7. Auto retract Landing Gear (front legs)
RET/ALL
once safely hitched. FRONT
8. Turn unit off and Activation Switch OFF ON
9. Remove chocks from wheels before towing.
C A U T I O N : R E A D I N S T R U C T I O N M A N U A L 6 6 3 8 5 B E F O R E U S E
EXT/FRONT
RET/FRONT
10/9/06 MPD 70335