AUMA Part-turn gearboxes GS 50.3 - 250.3, primary reduction gearings VZ 2.3 - 4.3_GZ 160.3 - 250.3 - Manual (Page 7)

3. Transport, storage and packaging
3.1 Transport
.
Transport to place of installation in sturdy packing.
.
If mounted together with actuator:
Attach ropes or hooks for the purpose of lifting by hoist only to the gearbox and
not to the actuator.
.
If eyebolts are supplied with the gearbox, they should be used to lift the gearbox
only and not the valve
3.2 Storage
.
Store in well-ventilated, dry room.
.
Protect against floor dampness by storage on a shelf or on a
wooden pallet. .
Cover to protect against dust and dirt.
.
Apply suitable corrosion protection agent to bare surfaces.
In case worm gearboxes are to be stored for a long period
(more than 6 months), the following points must be observed additionally:
.
Prior to storage: Protect bare surfaces, in particular the output drive parts and
mounting surface, with long-term corrosion protection agent. .
Check for corrosion approximately every 6 months. If first signs of corrosion
show, apply new corrosion protection.
3.3 Packaging Our products are protected by special packaging for the transport ex works. The
packaging consists of environmentally friendly materials which can easily be
separated and recycled.
For the disposal of the packaging material, we recommend recycling and collection
centers.
4. Fitting the handwheel For worm gearboxes designed for manual operation the handwheel may be
supplied separately. Fitting is done on site according to figure A.
7
Operation instructions Worm gearboxes GS 50.3 – GS 250.3
Figure A: Handwheel
Ball handle
(option)
Spacer
(may be required)
Circlip
Handwheel
Worm shaft
gearbox
Circlip
Spacer
(may be required)