1 questions and answers – Avision AV360CS User Manual
Page 35
6-2
6.1 Questions and Answers
Question:
When I power on the scanner, it makes noise and will
not stand ready.
Answer:
There are two possibilities:
1) You forgot to unlock the scanner. Please unlock the
scanner by turning the switch to the "use" position.
2) You did not place the scanner on a level surface.
Please settle the scanner on a level surface.
Question:
The scanner has been powered on, but the lamp does not
light up.
Answer:
The lamp is out of order. In this case, please contact
your local dealer to replace the lamp. The life time of the
lamp is about 10,000 hours.
Question:
The system would often hang up during scanning.
Answer:
Please check
1) If the cable is firmly seated;
2) Only 2 SCSI terminators can be connected to your
SCSI daisy chain. One is at the end of the SCSI device,
another is already in your host adapter.
Question:
Why is it the scanned image always comes out too
dark?
Answer:
1) Modify the Gamma setting to 1.8 for your monitor
and,
when printing, set Gamma to 2.2 for your printer.
2) Use the Brightness setting of the TWAIN user
interface
to get a brighter image.
Question:
Why does Image scanned in line art mode appear to be
much coarser than the original?
Answer:
Use the Brightness or Threshold setting to control the
line art image.