Avision FB6000 User Manual
Page 39
6-2
Question: To get image from the scanner is no problem. But
when scanning, the scanner or
the system will often crash.
Answer:
1) Please check if the cable is firmly seated.
2) Please note only two SCSI terminators can be
connected to your SCSI daisy chain. One is at the end
of the SCSI device, the other already in your host
adapter.
Question: While scanning, the scanner often makes noises,
or it scans back and forth.
Answer:
Usually this means the memory of your computer is not
enough or the speed of your CPU too slow. Please try to
increase your memory to at least 32M or replace your
CPU with Pentium or later.
Question: Why is it that the scanned image always comes out
to be too dark?
Answer:
1) Modify the Gamma setting to1.8~2.2 for your monitor
and, when printing, set the Gamma setting to 2.2
for your printer.
2) Adjust the Brightness setting from the TWAIN
user interface to get a brighter image.
Question: The scanner works well except for the line art image. The
lines in the image seem to be much thicker than the
original one.
Answer:
Increase the Brightness or adjust the Threshold setting to
improve line art image.