Avlex ACT-71Ta Miniature Ultra-Wideband - Manual (Page 9)

14 15
ERR Message
! When “ERR” appears in the display it indicates
that an operational error has occurred. Please
refer to the following codes to diagnose which
error you are experiencing.
ERR no01 EEPROM is not being programmed or internal
data error.
ERR no02 For testing only.
ERR no03 The frequency you want to program is above
the switching bandwidth of the transmitter.
Use a receiver with an appropriate frequency
group. (At this time the microphone is still
operating and the frequency remains
unchanged. To clear the displayed "ERR"
message, switch the handheld transmitter off
and on again.)
ERR no04 The frequency you want to program is below
the switching bandwidth of the transmitter.
Use a receiver with an appropriate frequency
group. (At this time the microphone is still
operating and the frequency remains
unchanged. To clear the displayed “ERR”
message, switch the handheld transmitter off
and on again.)
! “Group” & “Channel” : When both the group
and channel numbers are displayed, it means that
you are using the pre-programmed frequency of
the receiver.
! “Channel” Only : If “Channel” only is displayed,
it means that you are using a frequency which is
not pre-programmed.
! Press and hold for 2 seconds to power on & off.
“OFF...” - Power Off
! When the power switch is turned off, the LCD will
show “OFF...” (for Power Off) first and then the
system will shut down and no further messages
will be displayed.
Power Button
OFF...
Wideband Bodypack Transmitter Wideband Bodypack Transmitter
! Indicates the power remaining in the transmitter
battery. When the battery has less than 10%
power remaining it must be replaced or
recharged. If an under voltage condition
continues, the LCD will show “OFF...” and the
system will shut down to prevent being overly
discharged.
Battery Status
100% 80% 60% 40% 20% 10%