Avlex ACT-30T Bodypack Transmitter - Manual (Page 5)

Operating Instructions
(Figure 2)
! The audio gain level is factory preset at
Microphone-Low level. Guitar setting is
recommended at LINE level.
!
!
Insert the lavalier, headset microphone or
instrument cable into the audio input connector
before power ON the transmitter.
Tighten the connector screw clockwise direction
as shown in (Figure 2) for a secured fit.
The ridge on the
connector must align and
match the indentation on
the socket when inserting
for a proper fit.
Capsule Connector
Headset
Lavalier
Antenna: Flexible 1/ 4 wave transmitting
antenna.
Transmitter Housing: Holds PCB board and
wires.
LCD Panel: Display transmitter parameters.
SET Button: Changes audio gain & RF power &
LOCK settings.
MODE Button: To access and select parameters
modes such as audio gain & RF power levels.
Power Button: Press and hold 2 seconds to
power ON or OFF.
ACT IR Port: Align and syncs the transmitter and
receiver frequency automatically.
Battery Compartment: Holds 2 'AA' batteries.
Battery Cover: Hinged cover opens to provide
access to 2 'AA' batteries.
External Mute Connector: When an external
mute switch cable, MJ-70 (optional) is connected,
user can manually mute and un-mute the audio
temporary.
Belt Clip: Detachable and reversible design
allows the transmitter to be worn on a belt,
waistband, or guitar strap ( . Figure 1)
4 4
5 5
6 6
7 7
8 8
9 9
10 10
11 11
12 12
13 13
3 3
4 5
Bodypack Transmitter Bodypack Transmitter
(Figure 1)
07 03
CH GRP
07 03
CH GRP