B&K Precision 3001 - Datasheet - Manual

24
3001
2005B
One Year Warranty
One Year Warranty
MAIN OUTPUT
Frequency Range
100 kHz to 150 MHz (up to 450 MHz on third harmonics)
A) 100 kHz-300 kHz
B) 300 kHz-1 MHz
C) 1 MHz-3.2 MHz
D) 3 MHz-10 MHz
E) 10 MHz-35 MHz
F) 32 MHz-150MHz
(96-450 MHz on harmonics)
Dial Accuracy ±3%
RF Output Level Continuously variable. Step attenuator provides approximately
20 dB of attenuation
Maximum Output Approximately 100 mV rms to 35 MHz. Continuously variable
in hi or lo step, at least 20 dB range of adjustment
FREQUENCY MONITOR OUTPUT
Frequency
100 kHz to 150 MHz
Level 50 mV rms min. fixed, unmodulated signal
AMPLITUDE MODULATION
Internal
Frequency 1 kHz; level continuously variable. Modulation signal
available at front panel jack; fixed 1 V rms (min) into approx. 10 k
Ω
External Frequency 50 Hz to 20 kHz
Sensitivity Approximately 100 mV rms
POWER SOURCE 120/220/240V ±10%, 50/60 Hz
GENERAL
Dimensions
(HxWxD) 5.91 x 9.84 x 5.12" (150 x 250 x 130 mm)
Weight 5.5 lbs. (2.5 kg)
Frequency Range x1 range 20 Hz to 1.5 kHz (23 steps), x100 range 2 kHz
to 150 kHz (23 steps)
Accuracy 20 Hz through 100 kHz (±3% or less), 120 kHz and
150 kHz (±5% or less)
Output Control 0dB/-20dB attenuator switch and variable amplitude control
Output impedance approx. 600 Ω
SINEWAVE CHARACTERISTICS
Output Voltage
>1.2V rms at max. setting (no load)
Output Flatness (Short term) 20 Hz to 150 kHz ±0.5dB ( reference frequency 1 kHz)
Distortion 200 Hz—15kHz 0.5% (THD) or less, 50 Hz—28 kHz 0.1% (THD)
or less, 20 Hz—100kHz 0.3% (THD) or less
SQUARE WAVE CHARACTERISTICS
Output Voltage
> 5V p-p at maximum setting
Rise and Fall Time Less than 0.5microseconds
Sag Less than 5% at 20 Hz (DC coupled)
Over Shoot <2% from maximum output, to 50mV p-p
Duty Ratio 50% +5%
SYNC OUTPUT CHARACTERISTICS
Output Voltage
>1.2V rms (no load)
Output Impedance 1k Ω +5%
Other specifications same as sinewave characteristics
GENERAL INFORMATION
Operating Temperature
0°C to +50°C; specifications apply from 10°C to 30°C, <80% R.H.
Storage Temperature -20°C to +60°C, without battery
Power Requirements 9V battery NEDA 1604A
Battery Life 35 hours typical with Alkaline
Battery Indicator LED indicates low battery
Dimensions (HxWxD) 6 x 3.3 x 0.9" (150 x 82 x 21mm)
Weight 7 oz. (200 g) including battery
Model 3001
20 Hz-150 kHz Sine/Square Wave Audio Generator
■ Sine and square wave generator
■ 20 Hz to 150 kHz in 46 steps
■ Low distortion R-C oscillator
■ Variable output control
■ Compact, fully portable, light weight
■ Low battery indicator
Model 2005B
150 MHz RF Signal Generator
■ 100 kHz to 150 MHz on six bands
■ Output to 450 MHz on harmonics
■ AM modulation, internal or external
■ Frequency monitor output for external
frequency counter
■ Step and variable attenuation
Specifications
model
2005B
SUPPLIED: BNC to Insulated Clip Output Cable, Detachable Power Cord,
Instruction Manual
SUPPLIED: Two standard banana plug to insulated clip test leads, 9V battery,
Instruction manual
Specifications
model
3001
Accessories
Accessories