B&K Precision 4013B - Manual - Manual (Page 16)

4007B/4013B – Operating Manual
16
3.13.1 Selecting a Standard Waveform
You can select several standard waveforms as: sine, triangle, square. Creating a standard
waveform requires selecting the waveform type, parameters and their settings that define the
waveform.
Generating a standard waveform requires the following:
* Selecting the waveform
* Setting the output frequency
* Setting the output amplitude and offset
3.13.2 Setting the Output
To set the output channel, press the Output ON key. The key will lit indicating the output is
enabled.
3.13.3 Using Voltage Offset
Through the offset parameter you can add a positive or negative DC level to the output
waveform.
To set voltage offset:
1. Select a waveform to display its menu.
2. Press F3 :OFST to display the offset setting.
3. Use the rotary input knob or the numerical keys to set the voltage offset.
To turn the voltage offset OFF, repeat the steps above, but set the offset voltage level to 0.
3.13.4 Storing and Recalling a Waveform Generator Setup
You can store up to 9 front-panel setups inside the internal non-volatile flash memory. When
you recall a stored setup, the front-panel settings change to match the settings in the stored
setup.
Storing Setups
To store the front-panel setup:
1. Press UTILITY to display the menu.
2. Press F2:STORE to select the Store mode.
3. Use the rotary input knob to select a buffer number. Valid buffer numbers range from 1 to 9.
Buffer 0 is a read-only buffer that contains the default setup/power-on settings.
The function generator will overwrite and store settings into a buffer that had settings
previously stored inside without a warning.