B&K Precision 889B - Manual - Manual (Page 17)

16
2.2.4 DC Resistance Measurement
The DC resistance measurement measures the resistance of an unknown component by 1VDC. Press the
L/C/Z/DCR key to select the DCR measurement. The LCD will display:
2.2.5 AC Impedance Measurement
The AC impedance measurement measures the Z of an unknown device. Press the L/C/Z/DCR key to select the
Z measurement. The LCD will display:
The testing level and frequency can be selected by pressing the Level key and Freq key, respectively.
2.2.6 Capacitance Measurement
To measure the capacitance of a component, users may be able to press the L/C/Z/DCR key to select either Cs
(Serial Mode) or Cp (Parallel Mode) measurement mode. If the serial mode (Cs) is selected, the D, Q and ESR
can be shown on the secondary display. If the parallel mode (Cp) is selected, only the D and Q can be shown on
the secondary display. The following shows some examples of capacitance measurement:
The testing level and frequency can be selected by pressing the Level key and Freq key, respectively.
2.2.7 Inductance Measurement
Press the L/C/Z/DCR key to select Ls or Lp mode for measuring the inductance in serial mode or parallel mode.
If the serial mode (Ls) is selected, the D, Q and ESR can be shown on the secondary display. If the parallel mode
(Lp) is selected, only the D and Q can be shown on the secondary display. The following shows some examples
of inductance measurement:
The testing level and frequency can be selected by pressing the Level key and Freq key, respectively.