Baldwin Madrina LH Dummy Lever - Manual

MEASURE
BACKSET
1. Measure and Prepare door
Measure your door for a backset of 2-3/8” (60mm) or 2-3/4” (70mm).
Refer to the template.
Drilling instructions for door preparation.
1. Place desired fold line of template (above) on door edge with centerline approxi-
mately 38’’ (965mm) from floor.
2. Mark screw hole centers.
3. Where marked, drill 1/8’’ diameter pilot holes, 3/4” (19mm) deep.
Place lever or knob onto assembly.
3. Install knobs / levers
Secure assembly to door with screws.
2. Install Trim
Tighten set screw to secure.
TEMPLATE PLANTILLA
Dummy Knobs and Levers Installation Instructions
Lifetime Warranty
This product comes with a lifetime mechanical and finish
warranty to the original residential user against defects in
material and workmanship as long as the original user occupies
the residential premises upon which the product was originally
installed. This warranty DOES NOT COVER scratches; abrasions;
deterioration due to the use of paints, solvents, or other
chemicals; abuse; misuse; or product(s) used in commercial
applications. Upon return of a defective product to Baldwin
Hardware Corporation, Baldwin may repair or replace the product
or refund the purchase price. Baldwin is not liable for incidental
or consequential damages. Some states do not allow the
exclusion or limitation of incidental or consequential damages,
so the above exclusion may not apply to you. This warranty gives
you specific legal rights and you may also have other rights that
vary from state to state. If a mechanical or finish defect occurs,
please call 1-877-315-7853 in the U.S. and Canada or return it
to Baldwin Hardware Corporation, Consumer Services, 19701 Da
Vinci, Lake Forest, California 92610.For customers outside of the
U.S. and Canada, claims under this warranty must be made only
to either the place of purchase or to the listed importer.
Prestige Series
www.baldwinprestige.com