Baldwin Renssalear Entrance Trim User Manual
Page 3
For 1-3/4" doors, fold the yellow lock template
and attach to door using Installation Template
Guide. Mark door at appropriate locations for
lock and trim. MARK APPROPRIATE BACKSET.
(Extra thick door conditions, see General Notes.)
Metal template 8498.000 is available for purchase.
6
7
Mark Door
Drill Holes
8
Drill appropriate holes as indicated on yellow
lock template. DO NOT OVERSIZE HOLES.
Only top two holes are drilled for knob to
knob and lever to lever sets.
Install Lock
Insert Spindle
11
Size Thumbpiece
12
Drill two pilot holes for the lock face, adjust the
bevel and install the lock. Shim between the lock
and door on cylinder side as shown to prohibit
the cylinder from pulling the lock case off center.
(Failure to shim the lock may cause the cylinder
to sit unevenly on the surface of the trim.)
For handleset trim install the spindle from the
inside with V groove facing bottom door hinge
and thread the screw and lock washer into
the spindle from the outside. Tighten securely.
For knob to knob and lever to lever sets, install
spindle from outside - go to step 13.
Cut the thumbpiece so that it will fully
engage the lift lever on the bottom of
the lock.
Place the cylinder through the trim. Partially insert
key into cylinder. Thread the cylinder into the lock
until it is against the trim and Baldwin name is
horizontal. For knob to knob and lever to lever
sets - Install aligning bushing and fasten trim with
supplied screws. Remove bushing - go to step 16.
Start the thru-bolts which will hold the
exterior trim. (Use screw cover washer
under the bottom thru-bolt.) Tighten
both securely.
Install Thru-Bolts
Install Cylinder
13
Thread the cylinder plug into interior side of
lock. Place a strip of tape over plug to keep it
from turning. Notch must be located as shown.
(Double cylinder functions: OMIT THIS STEP.)
Install Cylinder Plug
9
10
Cut
Cut Relief Pockets
Cut the relief pockets 3/8" deep on both
sides for the Latch Hinge, 2-1/2" and 2-3/4"
backset only. (Does not apply for 1" front.)
Metal
Paper
Shim
14