Baldwin Soho AC Z-Wave Deadbolt - Manual (Page 6)

6
a. Press the program button on the interior unit once.
b. Enter in 4 to 8 digit code onto the keypad.
c. Press the “LOCK” button to save code.
Programming the 1st user code.
How the keypad works:
Each button represents two numbers (i.e. 1 and 2 for the
first button). You only need to push the button once to get
either 1 or 2. For example: If your code is 1-2-5-6-8,
■ Press the
1 2
button once to get number 1.
■ Press the
1 2
button once to get number 2.
■ Then press the
5 6
button once to get number 5.
■ Then press the
5 6
button once to get number 6.
■ Finally press the
7 8
button once to get number 8.
b. Note that the turnpiece is functioning properly when it is in the vertical
position when unlocked or in the horizontal position when locked.
8. Continued.......
9. Programming a User Code.
● A programmed code can be from four (4) to eight (8) digits long.
● For maximum security an 8 digit code is recommended.
● Up to 2 user codes can be entered.
● Excess delay in the programming steps once started will cause unit to
beep twice and will require you to restart from step (9a) below.
Continued
a. Press and hold the “LOCK” button on the exterior keypad, while fully in-
serting the battery pack into the interior assembly (the tab on the pack must
face out - see illustration). Hold down lock button until you hear 2 beeps
(about 20 seconds). It is very important that this process is allowed to
finish properly.
TURNPIECE
TURNPIECE
TURNPIECE
TURNPIECE
LoCKeD LoCKeD UnLoCKeD UnLoCKeD
Program
Button
LOCK
Button