Baldwin R044 Oval Rope Rose User Manual
Page 2
9. Slide a nylon
washer onto the
base of both knobs
or levers. Slide the
spindle with the
previously attached
knob or lever into
the latch with the set
screw pointed down
and toward the
hinges of the door.
Secure the other
knob or lever to the
exposed spindle
end.
Follow Steps #1 through #4 in the Single Cylinder Installation
section before proceeding to Step # 1.
3. Insert (2) #10
screws through inside
cylinder and thread
into outside cylinder.
Place cylinder cap
over inside cylinder
and secure with inside
cylinder ring.
4. Place interior plate
onto door. Thread
retainer onto adaptor.
Do not fully tighten.
Install #8 oval head
screws into door. Do
not fully tighten.
5. Insert key to check
operation of deadbolt.
Tighten all screws and
retainers.
Rotate key again to
check operation of
deadbolt
6. Insert the spindle
into a knob or
lever. Align scribed
mark with correct
door thickness and
secure with set
screw.
7. Slide a nylon washer
onto the base of both
knobs or levers. Slide
the spindle with the pre-
viously attached knob or
lever into the latch with
the set screw pointed
down and toward the
hinges of the door.
Secure the other knob
or lever to the exposed
spindle end.
SINGLE CYLINDER INSTALLATION – CONTINUED
©2011 Baldwin Hardware Corporation, Lake Forest, CA PK.2718
1. a. Carefully break
off cylinder tailpiece at
required mark for your
door thickness.
Caution: Use (2)
pairs of pliers as
shown or tailpiece
will be damaged.
b. Align tailpiece with
slot. Keep tailpiece
vertical and curved
toward right side of hole
as illustrated.
2. Insert the cylinder
into ring. Slide the
cylinder tailpiece into
the deadbolt and place
cylinder & ring into
outside plate.
Keeping tailpiece
vertical and curved
toward right side
of the hole, insert
inside cylinder with
threaded collar into
the deadbolt.
DOUBLE CYLINDER INSTALLATION – CONTINUED
DOUBLE CYLINDER INSTALLATION
CYLINDER
RING
OUTSIDE
CYLINDER
INSIDE
CYLINDER
COLLAR
OUTSIDE
CYLINDER
INSIDE
CYLINDER
TOP VIEW
INSIDE CYLINDER
RING
CYLINDER CAP
1-3/4”
SET SCREW
SPINDLE
TAILPIECE
CYLINDER
2-1/4”
2”
1-3/4”
SLOT
B.
CYLINDER
OUTSIDE
RING
OUTSIDE PLATE
DEADBOLT
OUTSIDE
ADAPTOR
#10 X 1-7/8”
CYLINDER SCREWS
COLLAR
CYLINDER
INSIDE PLATE
#8 x 3/4” OVAL
HEAD SCREWS
CYLINDER
CAP
INSIDE RING
(THREADED)
#8 X 3/4” SCREWS
RETAINER
FACE
PLATE
KNOB
SET SCREW
SPINDLE
1-1/4”
FLAT HEAD SCREWS
INSIDE
ADAPTOR
ALIGNMENT
BUSHINGS
ALLEN
WRENCH
LATCH
DOUBLE CYLINDER INSTALLATION
A.
CYLINDER
TAILPIECE
Consumer Help Line 1-800-566-1986
or
1-3/8”
NYLON WASHER
8. Insert the
spindle into a
knob or lever.
Align scribed mark
with correct door
thickness and
secure with set
screw.
1-3/4” 1-3/8”
SET SCREW
SPINDLE
or
7. Rotate turnpiece
to check operation
of deadbolt.
Tighten all screws
and retainers.
Rotate turnpiece
again to check op-
eration of deadbolt.
TURNPIECE