BlueBird H742G - Manual (Page 10)

10
Figures 4
Operator’s Guide
ASSEMBLY INSTRUCTIONS
Model 424
1. Remove wooden blocks. Note: Watch for nails
and wood splinters. Wear eye protection.
2. Carefully cut open side of carton.
3. Lawn Aerator 424 is shipped with handle
folded. Rear wheel control handle strapped
together with the clutch control. First cut
straps, then unfold handle. Lock handle in
position using the cam lock lever.
Model 530A
1. Wear eye protection. Remove wooden blocks.
NOTE: Watch for nails and wood splinters.
2. Carefully cut open side of carton.
3. Lawn Aerator is shipped with handle folded.
Lock handle in position using the cam lock
lever.
3. Lawn Aerator is shipped with the handle
detached. Mount the handle using 2 each ½”
wrenches.
(A) Slide handle onto handle mounting
brackets (see Figure 4).
(B) Insert and tighten fasteners, which
are located on handle mounting
brackets (see Figure 5-A). For further
detail on assembly, see parts section.
4. Connect top of control rod to rear wheel
control handle with fasteners located on rear
wheel control handle (see Figure 5-B) For
further detail on assembly, see parts manual.
5. Connect bottom of control rod to OUTER side
of lever on the torque arm using the fastener
assembly (see Figure 5-C).
6. Run the clutch cable through the guide hole in
the handle bracket support bar located at rear
of the deck (see Figure 4).
7. Attach end of cable to the “S” hook located on
the belt idler pulley.
8. (Honda Engines Only) Connect the throttle
cable by attaching the throttle spring to the
throttle/clutch control lever. (see Figure 4)
Model 742
1. Wear eye protection. Remove wooden blocks.
NOTE: Watch for nails and wood splinters.
2. Carefully cut open side of carton.
Figures 5