Brickcom OB-500Af Series - Manual (Page 16)

13
a. PoE Connection
For the Power over Ethernet connection, construct the PoE cable using
the pin definitions of the RJ45 connector below and refer to step 5 for
instructions on how to install the Water Proof Connector. Once the
PoE cable has been constructed using the waterproof connector, pass
the RJ-45 cable from the camera through the bracket and connect it to
the PoE cable.
RJ45 Connector
Pin No. Function
Pin 1 Transmit Out+ (Tx+)
Pin 2 Transmit Out- (Tx-)
Pin 3 Receive In+ (Rx+)
Pin 4 DC 48V
Pin 5 DC 48V
Pin 6 Receive In- (Rx-)
Pin 7 48V_GND
Pin 8 48V_GND
4.2 Camera Connection
The Bullet Series is DC12V and PoE compliant, so there are two options for
connecting the camera to a power and Ethernet source. The camera can
either be connected to a PoE-enabled switch or a non-PoE switch.
a. If using a PoE-enabled switch:
i. Use a single Ethernet cable to connect the camera to the PoE-enabled
switch.