BatteryMINDer E12248-AA-Series - Manual (Page 9)

BatteryMINDer ®
Aviation-Adjusted Models E 12248-AA-S2, S3 & S5
Rev. C-071213-1 Page 9 P/N VDC E 12248-AA-Sx-MNL
SIMPLIFIED OPERATING INSTRUCTIONS
Read and thoroughly understand ALL SAFETY Instructions, pages
3 - 7 including Preparing to Charge, DC Connection Precautions,
Unit Location and Qualifying Your Battery BEFORE proceeding
further.
1. Attach Battery Clips ( 7 ) (supplied), to output cordset of charger ( 4 ).
2. Attach output to battery terminals:
RED band = Positive +
BLACK band = Negative -.
3. Ambient Temperature Sensor, ATS-1 ( 8 ), comes already installed on
the Temperature Sensor input connector ( 3 ). Do not detach. The
Ambient Temperature Sensor (ATS-1) is mandatory when used
with all Aviation batteries.
4. Plug AC power cord ( 5 ) into a 220 - 240 Vac electrical outlet.
5. Observe Reversed Polarity GREEN/RED LED indicator ( 1a ):
If lit RED, reverse battery connector attachments on battery.
6. Observe Charging - Maintenance/Desulfating GREEN LED
indicator ( 1c ) :
Solid = charging
Blinking = maintaining battery(s).
Charger will automatically start within 30 seconds or less.
7. Observe Battery Connected - Error LED Indicator ( 1a ):
Must be lit GREEN 1 .
Be sure Maintaining - Desulfating LED ( 1c ) is BLINKING before leaving
unit for an extended period of time. Otherwise, press & hold the
Maintenance button ( 2 ) for 3 seconds.
IF IN DOUBT REGARDING ANY OF THE ABOVE, REFER TO Detailed
Operating Instructions, page 12.
1 See full instructions if not lit GREEN.