Bird B Gone Bird Wire 2000 - Manual

FAX: 949-472-3116
[email protected] • www.birdbgone.com
FOR TECHNICAL ASSISTANCE CALL
1-800-392-6915
2000
BIRD WIRE
TM
Installation Instructions
Purpose
Bird Pressure
Bird Type
Overview
Installation Tips
For ledges and areas where large birds
have been temporarily “resting”, and where
a low profile (low visibility) product is
essential.
Light to Medium
Pigeons, Seagulls and Larger Birds
An anti-perching system which offers
low cost, low visibility solution to bird
infestations. Bird Wire is a nylon coated
wire tensioned by springs between stainless
steel posts which, when mounted, creates
an unstable landing roosting area for pest
birds. Bird Wire carries a five year warranty.
1. Measure carefully the width of the ledge of surface
where the Bird Wire is to be installed.
2. The first row of Bird Wire should be no more than
1” from the edge of the ledge.
3. Rows of Bird Wire should be no more than 3”
apart.
4. The last row of Bird Wire should be no more than
1” from the back wall.
5. It is best to stagger the height of rows of Bird Wire
to enhance the destabilized landing surface.
6. Bird Wire should not exceed 5ft. from post to post,
otherwise birds will be able to press down and
defeat the wire.
7. Bird Wire should be installed in 10ft. sections (or
less). A section is the length of wire between two
anchor posts, including a center post at 5ft. with a
spring and tie down crimp.