4 oper ation, P.6 – Camco Tecton series User Manual
Page 17
SPEAKON left
SPEAKON right
Input
Channel A
Input
Channel B
4 OPER
ATION
USER MANUAL
TECTON POWER AMP SERIES
P.6
3.8.5 SPEAKON Connection
Both SPEAKON connectors are connected to channel A and channel B outputs.
The pin configuration of the SPEAKON connectors is as follows:
SPEAKON right: Pin + Channel A
signal
(View at the back)
Pin -
Channel A
ground
Pin 2+ Channel B
signal
Pin 2-
Channel B
ground
SPEAKON left:
Pin + Channel B
signal
(View at the back)
Pin -
Channel B
ground
Pin 2+ Channel A
signal
Pin 2-
Channel A
ground
WARNING !
SPEAKON connectors marked with the lightning flash indicate high vol-
tages that are potentially life threatening.
Wiring to these terminals requires installation by an instructed person or
the use of ready-made leads or cords.
Custom wiring should only be made by qualified personnel.
To prevent electric shock, do not operate the amplifier with any of the con-
ductor portion of the speaker wire exposed.
NOTE:
For reasons of safety and performance, use only high-quality fully insu-
lated speaker cables of stranded copper wire. Use the largest wire size that
is economically and physically practical, and make sure the cables are no
longer than necessary.
IMPORTANT:
When connecting speaker cabinets in parallel, always use all the contacts
in both SPEAKON connectors. If not, this may cause permanent damage to
the connectors and considerably reduce performance.