Camco D-Power 1 - Manual (Page 15)

D - P O W E R
S E R I E S
Lower SPEAKON
Upper SPEAKON Input
Channel A
Input
Channel B
USER MANUAL
D-POWER 05/1
P.14
3.4.2 SPEAKON ® Connection
Both SPEAKON ® connectors are connected to channel A and channel B
outputs. The pin configuration of the SPEAKON ® connectors is as follows:
Upper SPEAKON ® : Pin 1+ Channel A signal
Pin 1- Channel A ground
Pin 2+ Channel B ground
Pin 2- Channel B signal
Lower SPEAKON ® : Pin 1+ Channel B ground
Pin 1- Channel B signal
Pin 2+ Channel A signal
Pin 2- Channel A ground
ATTENTION!
Channel B's output polarity is inversed. This means that the active
(hot) amplifier output is connected to the negative SPEAKON
® con-
tact. Connecting this contact to ground or earth inside loudspeakers,
cabling or other equipment would short-circuit the amplifier output
stage!
WARNING !
SPEAKON
® connectors marked with the lightning flash indicate high
vol tages that are potentially life threatening.
Wiring to these terminals requires installation by an instructed person
or the use of ready-made leads or cords.
Custom wiring should only be made by qualified personnel.
To prevent electric shock, do not operate the amplifier with any of the
con ductor portion of the speaker wire exposed.
NOTE:
For reasons of safety and performance, use only high-quality fully in-
su lated speaker cables of stranded copper wire. Use the largest wire
size that is economically and physically practical, and make sure the
cables are no longer than necessary.
3 INST
ALLA
TION