Lexibook RCD170BB - Manual (Page 9)

9 English
AC OPERATION
To operate the unit using AC power, connect the small end of the AC power
cord to the AC power jack on the rear of the unit and insert the plug into an
AC outlet having AC 230V ~, 50Hz only. The batteries are automatically
disconnected when the AC adapter is used.
CAUTION:
• When not using AC power, disconnect the AC power cord from the wall
outlet and from the unit by pulling the plug (not the cord).
• Do not touch the AC power cord with wet hands.
• Fully insert the plug without exposing any part of the blade.
POWER SOURCES (CONTINUED)
8
NOTE: The socket-outlet shall be installed near the equipment and shall be
easily accessible.
WARNING: Mal-function or loss of memory may be caused by strong
frequency interference or electrostatic discharge. Should any abnormal
function occur, unplug the AC/DC adapter from the mains socket and replug
it again.
RCD170BB_02IM0449.qxd:CD2849.QXD 27/10/09 17:13 Page 9