Lexibook RCD100SP - Manual (Page 5)

Copyright © Lexibook 2007
ENGLISH
5
BATTERY OPERATION
This CD player operates with 6 X C size (LR1) batteries (not
included) or with a with 9V 600mA adapter with a positive
centre . Only use batteries or adapter of the same or
equivalent types as recommended.
Battery installation
1. Open the battery compartment located
under the CD player using screwdriver.
2. Insert 6 X ‘C’ size (UM-2) batteries according
to the polarity indicated in the bottom of the
compartment.
. Close the battery compartment.
Do not use rechargeable batteries.
Non-rechargeable batteries are not to be recharged. Recharge
able batteries are to be removed from the toy before being charged.
Rechargeable batteies are only to be charged under adult supervision.
Different types of batteries or new and used batteries are not to be
mixed. Only batteries of the same or equivalent type as recommened
are to be used. Batteries are to be inserted with the correct polarity.
Exhausted batteries are to be removed from the product. The supply
terminals are not to be short circuited. Do not throw batteries into a
fire. Remove the batteries if you are not going to use the CD palyer for
a long period of time.
WARNING: If the unit malfunctions or receives an electrostatic shock,
switch the unit off and on again using the POWER button. If this proves to
be ineffective, remove the batteries and/or perform the Reset procedure.
Adapter
This CD player also works with a 9V 600 mA, with positive centre
+ .
To connect to the mains, follow these instructions:
1. Check that the CD player is switched off.
2. Insert the DC plug, at the end of the AC adaptor cord into the DC input
jack, at the back of the unit.
. Plug the other end of the adaptor in an AC 20V – 50Hz power outlet.
A power adaptor is not a game. Switch off the power adaptor if you are
not going to use the product for a long period of time, this will avoid
overheating. While the game is powered by a power adaptor, do not play
with it outdoors. Check regularly the condition of the power adap tor and
its leads. If the latter becomes deteriorated, do not use them until they
are fully repaired.
+
RCD100SPIM.indd 5 12/03/2007 14:50:09