Lexibook DJ013 Series - Manual (Page 12)

ENGLISH
12
Non-rechargeable batteries are not to be recharged. Rechargeable batteries
are to be removed from the product before being charged. Rechargeable
batteries are only to be charged under adult supervision. Different types of
batteries or new and used batteries are not to be mixed. Only batteries of the
same or equivalent type as recommended are to be used. Batteries are to
be inserted with the correct polarity. Exhausted batteries are to be removed
from the product. The supply terminals are not to be short circuited. Do not
throw batteries into a fire. Remove the batteries if you are not going to use the
product for a long period of time.
WARNING: Mal-function or loss of memory may be caused by strong frequency
interference or electrostatic discharge. Should any abnormal function occur, remove
the batteries and insert them again.
Important note: all the files stored into the unit’s internal memory will be lost when
replacing the batteries. Make sure you transfer the files to your computer before
changing the batteries.
INSTALLING THE SOFTWARE AND THE CAMERA DRIVER
Follow these instructions to install the “Arcsoft MediaImpression ” software and the
camera driver on your computer system.
1. Insert the CD Software (included) in your CD-ROM drive. The CD will auto run,
and the installation menu will appear.
2. Click “Install Driver”, and then follow the instructions to install the camera driver.
3. You will need to reboot your computer after the driver installation. Once the instal-
lation is completed, the “Dual Mode Camera” folder will be automatically created on
your desktop.
4. Click “Arcsoft MediaImpression”, select the installation language and follow the
instructions to install “Arcsoft MediaImpression ”. The “Arcsoft MediaImpression ”
software offers many applications for photo editing and printing.
Note :
- If the CD does not auto run, click “Start”, “Run”, then type in “D:\autorun.exe” in the
Run dialog text box (where D:\ is your CD-ROM drive) and press Enter.
- You must install the driver before downloading pictures from the camera or using it
as a webcam.
- Make sure the camera is not connected to your computer before installing the
driver and the software.
TURNING THE CAMERA ON AND OFF
1. Press the Power on/off button to turn the camera on. The camera will make a
beep sound to confirm that it is ready for use.
2. Press and hold the Power on/off button for a few seconds again to turn it off.
3. To turn the unit off, you can also press repeatedly the MODE button until “Off” is
displayed on the LCD screen. Then press the shutter button to confirm.
Note : The camera will auto power off after 30 seconds of inactivity.
TAKING PHOTOS
Single shooting
You are already in “Single shooting” mode when you switch on the camera. Press
the shutter button to take a photo. The camera will beep to confirm that a picture is
taken. The number of pictures that you can take in memory is shown on the LCD
screen.
Continuous shooting
1. When you are in “Single shooting” mode, press the MODE button repeatedly until
the “Continuous shooting”
mode icon is displayed in the upper-right corner of
the screen. Press the shutter button within the next 5 seconds to take 3 pictures
continuously.
Note: When the camera’s built-in memory is full, the unit will play a double “beep”
sound when you press the shutter button to indicate that you can’t take any new
pictures.
Self-timer
1. In “Single shooting” mode, press repeatedly the MODE button repeatedly until
the “Self-timer” icon appears on the LCD screen. Then press the shutter button
within 5 seconds to turn on the self-timer function.
2. The digital camera will take a picture 10 seconds later.
Note: The self-timer feature is automatically turned off after the picture has been
taken.