Lexibook DJA100 - Manual (Page 31)

31
ENGLISH
2.0 Mega Pixel CMOS Sensor
Video mode, Capture mode, Playback mode
Electronic
1.5” TFT Screen
TF card (up to 32GB)
Video:[1920*1080(30fps)]/[1280*720(60fps)]/
[1280*720(30fps)]
Image:[2560*1920]/[2048*1536]/
[1600*1200]/[1280*960]/[640*480]
[3] /[5]/ [10] frames per shoot
Auto/50/100/200/400/800
-2EV~ +2EV
Auto/Daylight/Cloudy/Tungsten/Fluor H
Image: JPG Video: MOV
Lithium-ion battery(built-in)
Built-in
Built-in
82*47.2*27.1(mm)
About 75 g
SPECIFICATIONS TECHNIQUES
You can view your files on a television using an HDMI cable
(sold separately).
1. Plug the camera to the television using an HDMI cable (sold
separately).
2. Turn on the HDTV television and set it to HDMI mode.
3. Turn on the camera. The camera’s screen will turn opaque
and you will be able to navigate within your device from your
television.
CONNECTING THE CAMERA TO AN HDTV TELEVISION
1. Unscrew the screw (22) from the yoke joint.
2. Position the yoke joint (21) and its rubber pad around the
bicycle handlebars and tighten the screw (22) until it is firmly
attached. Ensure that this part is firmly screwed in again in order
to ensure effective fastening.
3. To use the waterproof case, insert the camera in the
waterproof case (19), and then re-close it using its latch,
ensuring that the latch is fully re-closed.
4. Position the waterproof case on the bicycle mount’s (23)
attachment screw and screw in the case until it is firmly
attached.
5. To adjust the camera’s position, loosen the screw (24) and
move the camera up or down, and then screw the screw in again
once the camera has been adjusted to the desired position.
Ensure that this part is firmly screwed in again in order to ensure
effective fastening.
Note: the waterproof case must be properly closed again and it
is only waterproof to a depth of 10 metres.
BICYCLE MOUNT (Assembly)
21
22
23
24
19
DJA100IM1363_6Sept_V06.indb 31 06/09/2013 5:38 PM