Lexibook ST5Z - Manual (Page 6)

6
ENGLISH
Copyright © Lexibook 2006
VCR Code SAT/CBL Code
AUX Code
Operational reset
Operational reset will erase all the set functions.
1. Simultaneously press and hold the SET button and TV.
2. Then, one after the other, press 9 – 9 – 0.
TV Code CD/DVD Code
Macro Keys
With one of the macro keys, you can operate a series of up to 15 functions by
pressing one single key. In other words, you will be able to execute several
control commands in the order they were stored by simply pressing the
MACRO key.
Programming the MACRO Key
1. Press and hold the SET button, then press the MACRO key. When the LED
lights up, release the two buttons.
2. Now press the buttons you would like to activate successively. (Press the SET
button to stop the programming mode).
3. Finally, press the MACRO key again. When procedure is completed, the LED
is off.
For example:
You wish to store the following control command sequence:
TV on – Switch to TV/VCR – VCR on – Play – Switch to TV.
Then, you have to enter :
SET + MACRO – TV – POWER – TV/VCR – VCR – POWER – PLAY – TV
– MACRO.
If more than 15 control commands have been selected or no button was pressed
for more than 30 seconds, programming stops automatically, the LED goes off
and the last MACRO settings will be stored.
Deleting the settings
1. To delete the MACRO key settings, press and hold the SET button and press
the MACRO key.
2. When the LED lights up, release the two buttons.
3. Press the MACRO key again. Any control command previously stored is now
deleted.
Noting the programmed code
Always write down the 3-digit code for your remote control after running the
search and saving the code. This may be useful if you need to reprogram your
remote control in the event of accidental cancellation. When searching the code,
the LED will flash corresponding to the numerals of the 3-digit code.
For example: For code 231, the LED would flash two times, then three times,
then once.
To find the code for your remote control:
1. Press a device key. Simultaneously press and hold the SET button and 1.
Release the 2 buttons. The LED lights up; its flashing indicates the first digit of
the code. If the LED does not turn on: digit = 0.
2. To display the second digit, press and hold the SET button and 2
simultaneously. The LED starts flashing.
3. To display the third digit, press and hold the SET and 3 simultaneously. The
LED starts flashing.
4. Repeat steps 1-4 to find the codes of the other devices.
ST5ZIM0136.indd 6 04/04/2006 18:07:21