Lexibook ST100 - Manual (Page 5)

Copyright © Lexibook 2007
5
ENGLISH
Channel (1-4-digit numbers) Number of storable channels
One digit
Two digits
Three digits
Four digits
15
10
7
6
Storing your favourite channels
Example: store channels 02, 38, and 56.
1. Press and hold the SET button and the FavCH button simultaneously until the
LED lights up.
2. Then, subsequently press
0 – 2 – SET – 3 – 8 – SET – 5 – 6 – FavCH.
And for 3 digit numbers press
0 – 0 – 2 – SET – 0 – 3 – 8 – SET – 0 – 5 – 6 – FavCH.
Only numerical keys 1-9 can be set. 1 to 4-digit channel numbers can be stored.
Once you have stored your favourite channels, simply press the FavCH button
to browse through the channels in the order they were stored and select one of
them.
To delete the channels from the memory:
1. Simultaneously press and hold the SET button and TV1
2. Then, one after the other, press 9 – 2 – 0.
Child Lock
In Child Lock mode, only the following buttons will be operative: POWER VOL+/-,
MUTE, DEVICE buttons SET and FavCH.
1. Simultaneously press and hold the SET button and TV1.
2. Then, one after the other, press 9 – 2 – 1.
To switch off the child lock mode:
1. Simultaneously press and hold the SET button and TV1.
2. Then, one after the other, press 9 – 2 – 2.
To delete the channels from the memory:
1. Simultaneously press and hold the SET button and TV1.
2. Then, one after the other, press 9 – 2 – 0.
Auto search
This search should be used only if Quick Search did not work.
1. Turn on the device to be controlled and aim the remote control at the device.
2. Press the respective DEVICE key on your remote control.
3. Press the SET key followed by the POWER button on your remote control.
Hold down both keys until the LED remains solid. Release both keys; the LED
starts blinking. The automatic search begins.
4. 5 codes are transmitted at a time; there is a 5-second period between each
transmission, approximately 9 minutes in total.
5. When your device switches off, then the correct code range has been found.
6. Promptly press the respective DEVICE key to auto search within these five
codes.
7. Go back to your device and switch it ON again (with original remote or using
the front panel buttons).
8. Aim the searching remote to it: when your device switches off, the correct
code has been found.
9. Press the respective DEVICE button to stop/store. The LED turns off.
10. During step 5, the SET button can be pressed to return to step 3
Check whether all applications of your device can be operated with the remote
control keys.
Tips for quick and auto search modes:
- Some devices cannot be powered on/off using the remote control. In such
case, use the PLAY button instead of POWER to check if the device responds to
the remote control.
- The search direction can be changed by pressing the CH+/- button.
- All the function buttons except POWER and PLAY can be verified without exit-
ing the quick search mode.
If no button was pressed for more than 30 seconds, setup stops automatically,
the LED goes off.
Should your remote control still not work, check the codes list again and
repeat the setup procedure (manual or code search) until you find the
correct code.
Storing your favourite channels and child lock
The FavCH key allows you to store your favourite channels or limit the number
of channels accessible to your children. The following number of channels can
be stored or retrieved using the FavCH button:
ST100.indd 5 4/9/07 18:05:17